Dicas Reparação GRUNDIG
Modelo - Chassis
Pesquisa: GRUNDIG Enviar Dica Resolvida
Resultados 797
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Grundig | CUC7350 | Tripping | R60027/28 0R46 gone hi res | ||
| Grundig | CUC7350 | St/by only | LM317T reg s/c by its heatsink clip | ||
| Grundig | CUC7350 | No sound | check sm trs to left of audio IC - mute sound in st/by & when told by micro - BC848C faulty in this case | ||
| Grundig | CUC7350 | No HT control | HT pot R60027 increased in value from 0R68 to 1R5 | ||
| Grundig | CUC7350 | mains fuse o/c, BUZ chopper tr s/c | dry joint C60029 470pf 1.6Kv also check D60011-14 & D60023/4 rects | ||
| Grundig | CUC7350 | Int start up | C60031 100µ 35v in psu | ||
| Grundig | CUC7350 | Dead IRFBC40 chopper MOSFET failure | Dry joints C60029 470pf. Check R60027/28 0R46, R60022 10R, D6011-14 D60023-24 1N4007 | ||
| Grundig | CUC7350 | Dead - Chopper FET & 2 rect diodes s/c | dry joint on C600 - blew again later due to arcing between FET & heatsink | ||
| Grundig | CUC7350 | Dead - 2.5A fuse blackened | T60020 IRFBC40 chopper tr s/c; D60013 1N4007 mains rect s/c; C60029 dry joints; R60023 1N4003 s/c; R60027 0R56 o/c | ||
| Grundig | CUC7350 | Dead | Chopper FET & control IC partial cure but all volts low until R60027/8 0R56 1w reistors replaced | ||
| Grundig | CUC7350 | "E" instead of "OK" shows when storing | Sw on with "Prog -" button depressed to clear "fault" | ||
| Grundig | CUC731KT | No start up | D633 1N4935 s/c | ||
| Grundig | CUC7306 | Auto tune problems | if auto tune used it defaults to wrong tv standard be aware! | ||
| Grundig | CUC7305 | no vid or sound | sm tr CT840 BC848B vid sw tr faulty | ||
| Grundig | CUC7303 | Won't go fully into st/by - crt heaters stay lit etc | Pin 1 IC676 should drop to 1.2v in st/by - was staying at 10.7v. BC848 sm tr downstream from pin 1 was faulty though checked ok |