Dicas Reparação PHILIPS





Pesquisa: PHILIPS

Resultados 13482

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
PhilipsGR1AX 14GR1227/05BDead - HT at 1.5v at power supply whistlingReplace SF2D41 protection thyristor (6641)
PhilipsGR1AX 14GR1221Deadresistor 3300 4R7 o/c.cap 2301 4,7uF 350V s/c on multi voltage pcb
PhilipsGR1-AXPoor tuning lock - no high channels.Tr7705 ( PH2369 )
PhilipsGR1-AXpic shifts to left, line tearing both intC2523 6µ8 50v int o/c line driver supply smoother
PhilipsGR1-AXNo tuningR3703 oc
PhilipsGR1-AXno sound or pic - low hum from spkrNo line drive due to C2058 22µ o/c connected to pin 11 IC7020
PhilipsGR1-AXdead - st/by light flashinght=70v - loptx faulty
PhilipsGR1AXWont stop in search tune C2031 22nF faulty - may read ok
PhilipsGR1AXWill not start up from coldTurn 95V preset down if set starts fault is in overvolts circuit try D6638
PhilipsGR1AXWidth excess & EW faultyTr7533 2SA1359 on crt base s/c & driver Tr7530 BC848 had failed
PhilipsGR1AXWhite Lines on bright scenes when heatedC2523 6µ8 line driver supply decoupler
PhilipsGR1AXWhistling noise (from LOT).1) Glue the plastic lugs of the LOT L5530 with silicon or equivalent lute (non-reactive) at the copper track side of the PWB to damp off vibrations which causes the wistling. 2) Apply a non Hitachi LOT L5530; 4822 140 10369. REMARKS : The
PhilipsGR1AXWEAK SOUNDCHECK DISC CERAMIC CAPS AROUND SOUND IF CHIP ESP C2033 ( 22nf )
PhilipsGR1AXVertical vibration in cold condition of the setChange R 3052 into 1,8 kOhm (4822 116 52249) and change C2053 into 150 nF (4822 121 41854)
PhilipsGR1AXUpdate Chassis manual; different types of micro-prUpdate Chassis manual; different types of micro-processors. ----------------------------------------------------------- In Chassis manual GR1-AX version 2: (GB) 4822 727 18084, (NL) 4822 727 18083, (D) 4822 727 18085 (F) 4822 727 18086, (E) 4822 727 18



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads