Dicas Reparação PHILIPS





Pesquisa: PHILIPS

Resultados 13482

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
PhilipsGR1AXTwo lines going around.Check/replace C2606 (68 uF; 4822 124 41599).
PhilipsGR1AXTuning unstableVoltage on D 6702 is not stable. Check/replace D 6702 (ZTK33B; 4822 130 30959)
PhilipsGR1AXTuning drift33v zener & dropper checked ok - was tuner
PhilipsGR1AXTuning - drift & flickering.Replace ZTK33B voltage stabiliser.
PhilipsGR1AXTripped at sw on 95v HT present at LOPTrNo line drive - R3100 1R in 9v current sensing risen to 4R
PhilipsGR1AXTo release hotel mode ( child lock ) .Put set on programme 38 , press either store & pr - ( to lock ) & store & vol - ( to unlock ) , or , press pr - & vol + ( to lock & u
PhilipsGR1AXTo over ride protection cct unsolder gate of THY6641 & SLOWLY power up via variac whilst monitoring HT at pin 6 of Loptx (should reach 95v)
PhilipsGR1AXTo check psu without LOP stage connectedDo not use 60w bulb as dummy load - psu will not start - ok to just dis coil L5660
PhilipsGR1AXSt/by only - 95v HT only 5vWith 100v ac I/p, HT = 80v ; any higher I/p shut down the set with pulsing reset line on micro; D6671 zener BZX79-F4V3 faulty
PhilipsGR1AXSt/by onlyC2631 22nF in st/by cct leaky
PhilipsGR1AXSpare part informationSpare part information ---------------------- In service manual "GR1-AX Version 2" the specific partslist for the /58R is not mentioned. For this /58R use parts: position 1000: tuner UV917E/Phono; service code 4822 212 23696 positions 1600, 2606, 3603, 6
PhilipsGR1AXSound varies with picture contentReplace wire link 9511 (near tuner) with a 6.2 volt zener diode BZX79-B6V2 (4822 130 34167) and change C2030 into 22uF (5322 124 41431)
PhilipsGR1AXSOUND SLOW TO RETURN AFTER CHANNEL CHANGETR7046 SC
PhilipsGR1AXSound slow coming on aft channel changeT7046 ( BC558 )
PhilipsGR1AXSound low volD6715 5v1 zener leaky (adj to micro IC7700) & disc ceramic caps around sound if chip - C2033 22nF



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads