Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | FL1.17 | Supply switch-off sometimes | Check the +5 stand-by. This voltage has to be 5.5V and may not vary. When the voltage drops below 5.2V the set switches-off. Cure: check D6266 for leackage (BZX79/F6V8; 4822 130 34278) or check T7268 for leackage (BD943F; 4822 130 62742). The 5.5V is meas | ||
Philips | FL1.17 | Supply +5V too low, black horizontal bar in picture. Bad sync. | Check/replace IC7551 (LM358N; 4822 209 70672) | ||
Philips | FL1.17 | Spook lines visible (vertical interference lines at weak signal). | Replace C2536 by 1,5 nF (4822 126 11501) and add item C2545 (1nF; 4822 122 31175) on the LSP. REMARKS : Introduced in production in week 9334. | ||
Philips | FL1.17 | Spook in picture | Use special antenna cables. Codenumbers: 4822 321 61224 PAL 1 meter 4822 321 61225 PAL 2 meter 4822 321 61226 SECAM 1 meter 4822 321 61227 SECAM 2 meter | ||
Philips | FL1.17 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
Philips | FL1.17 | Sometimes in protection, or hor. width varies | Check or resolder on LSP the pins of E/W bridge coil 5521. | ||
Philips | FL1.17 | Shuts off and on again on Pr.nr. 1 after 3 hours. | D6272 (BZX55B5V6) interruption when it becomes hot. | ||
Philips | FL1.17 | Shuts off and on again on Pr.nr. 1 after 3 hours. | D6272 (BZX55B5V6) interruption when it becomes hot. | ||
Philips | FL1.17 | Severe Moire patterning | Most modern Colour Televisions use Automatic Gray Scale Tracking and while the setting of the G1 may not seem to have a major effect on the picture brightness on a modern set, incorrect adjustment can have the effect of causing severe Moire patterning if | ||
Philips | FL1.17 | Set switched to EXT2 and back to programm. | Check D6145 (LL4148; 4822 130 80446). | ||
Philips | FL1.17 | Set inoperative only red or green LED. Supply was 141V but no EHT. | Line drive puls for T7506 (2SC4288A) too low. L5503 defective (Line drive coil; 4822 157 63252) | ||
Philips | FL1.17 | Set can only be operated with Remote Control | Check whether "Child Lock" is disabled. To check this, see "Frequently Asked Questions", "How to disable Child Lock". | ||
Philips | FL1.17 | Repeated light-up of the standby-led after switching-off from standby. | Change the following positions on the LSP: Position 3250 from 47 ohm into 62 ohm (4822 116 52198) Position 6251 from LLZ-C5V6 into LLZ-C7V5 (4822 130 80906) REMARKS :Introduced in production in week 9418. | ||
Philips | FL1.17 | Repair information | Repair information ------------------ In case of one of the line transistors T7504 or T7506 is defective, it is necessary to replace both transistors. Order number 4822 130 62934 (2x ON4673). | ||
Philips | FL1.17 | Red spikes in picture. | Check A/D converter IC7231 ON ECO box (SDA9205-2; 4822 209 31056). |