Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | FL1.16 | Small picture with flyback lines. The +141 is about 110V. | Check D6372 on LSP (LL4148; 4822 130 80446). | ||
Philips | FL1.16 | Shuts off and on again on Pr.nr. 1 after 3 hours. | D6272 (BZX55B5V6) interruption when it becomes hot. | ||
Philips | FL1.16 | Severe Moire patterning | Most modern Colour Televisions use Automatic Gray Scale Tracking and while the setting of the G1 may not seem to have a major effect on the picture brightness on a modern set, incorrect adjustment can have the effect of causing severe Moire patterning if | ||
Philips | FL1.16 | Set totally inoperative, no LEDs on. Supply hums. | R3252 220 kOhm (Start-up micro-sops) defective (4822 116 52258). | ||
Philips | FL1.16 | Set sometimes goes in STAND-BY and immediately switches ON again. | Replace position IC7120 on LFR box (PCF83C652P/AB/043) by P83C652FFP/50 V34D (4822 209 33289). REMARKS : Introduced in production in week 9337. | ||
Philips | FL1.16 | Set inoperative only red or green LED. Supply was 141V but no EHT. | Line drive puls for T7506 (2SC4288A) too low. L5503 defective (Line drive coil; 4822 157 63252) | ||
Philips | FL1.16 | Set can only be operated with Remote Control | Check whether "Child Lock" is disabled. To check this, see "Frequently Asked Questions", "How to disable Child Lock". | ||
Philips | FL1.16 | Repeated light-up of the standby-led after switching-off from standby. | Change the following positions on the LSP: Position 3250 from 47 ohm into 62 ohm (4822 116 52198) Position 6251 from LLZ-C5V6 into LLZ-C7V5 (4822 130 80906) REMARKS :Introduced in production in week 9418. | ||
Philips | FL1.16 | Repair information | Repair information ------------------ In case of one of the line transistors T7504 or T7506 is defective, it is necessary to replace both transistors. Order number 4822 130 62934 (2x ON4673). | ||
Philips | FL1.16 | Protection activated due to no +5V from LOT. | Check IC7551, LM 358N (4822 209 71825). If IC7551 has to be replaced, it is recommended: 1) for production code AG00-09 add diode BZX79-C18 (4822 130 31024) between 9240 and pin 8 of position 7551, with cathode to pin 8 of IC7551. 2) for production | ||
Philips | FL1.16 | Poor colors, no light in picture | Check IC7207 (SDA9205; 4822 209 31056). | ||
Philips | FL1.16 | PIP picture not in order. | Check R3345 (4822 111 41424) in PIP unit, check IC7755 (4822 209 63423). | ||
Philips | FL1.16 | Picture twists from top | Voltage of pin 8-IC7450 (TDA3654Q) on the LSP has raised to ca. 20 V. Check diode 6451 (BZX79/C3V6; 5322 130 34834 or BZX79/C10; 4822 130 61219) | ||
Philips | FL1.16 | Picture twists from top | Voltage of pin 8-IC7450 (TDA3654Q) on the LSP has raised to ca. 20 V. Check diode 6451 (BZX79/C5V6; 4822 130 80954). | ||
Philips | FL1.16 | Picture OK after some time | IC7207 (SDA9205-2; 4822 209 31056) defective when set is cold. |