Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | FL1.10 | Stripes in picture and after about 5 min. only snow. | Replace tuner FQ916BL (4822 210 10565). | ||
Philips | FL1.10 | Spook in picture | Use special antenna cables. Codenumbers: 4822 321 61224 PAL 1 meter 4822 321 61225 PAL 2 meter 4822 321 61226 SECAM 1 meter 4822 321 61227 SECAM 2 meter | ||
Philips | FL1.10 | Splitted characters with TXT (Bad starting of DVTB). | Add R3100 (1M 5% 0,5 W; 4822 116 52235), between pin 7 and pin 15 of IC7111 (SAA9042) on the LFR box. Change 4108 into 220nF 50V (4822 122 32927) on the LFR box. REMARKS : Introduced in production in week 9333. | ||
Philips | FL1.10 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
Philips | FL1.10 | Sometimes set switched back to standby. Only red LED on. | Microprocessor panel defective (4822 212 30803 and 4822 900 10423) | ||
Philips | FL1.10 | Sometimes in protection, or hor. width varies | Check or resolder on LSP the pins of E/W bridge coil 5521. | ||
Philips | FL1.10 | Set inoperative only red or green LED. Supply was 141V but no EHT. | Line drive puls for T7506 (2SC4288A) too low. L5503 defective (Line drive coil; 4822 157 63252) | ||
Philips | FL1.10 | Set can only be operated with Remote Control | Check whether "Child Lock" is disabled. To check this, see "Frequently Asked Questions", "How to disable Child Lock". | ||
Philips | FL1.10 | Poor colors, shaking picture | Check IC7366 color signal delay circuit (TDA4660). Replace by TDA4661 (4822 209 31714). When TDA4660 is replaced by TDA4661 also change the following components: - delete 2386, 3385 - change 3383 into 33k (4822 051 10333) - c | ||
Philips | FL1.10 | PIP picture not in order. | Check R3345 (4822 111 41424) in PIP unit, check IC7755 (4822 209 63423). | ||
Philips | FL1.10 | Picture twists from top | Voltage of pin 8-IC7450 (TDA3654Q) on the LSP has raised to ca. 20 V. Check diode 6451 (BZX79/C5V6; 4822 130 80954). | ||
Philips | FL1.10 | Picture twists from top | Voltage of pin 8-IC7450 (TDA3654Q) on the LSP has raised to ca. 20 V. Check diode 6451 (BZX79/C3V6; 5322 130 34834 or BZX79/C10; 4822 130 61219) | ||
Philips | FL1.10 | Picture twists from top | Voltage of pin 8-IC7450 (TDA3654Q) on the LSP has raised to ca. 20 V. Check diode 6451 (BZX79/C3V6; 5322 130 34834 or BZX79/C10; 4822 130 61219) | ||
Philips | FL1.10 | Picture often dark | Check IC7201 in High End-box (SAA9042P/A; 4822 209 31851) | ||
Philips | FL1.10 | Picture moved to the right | Voltage of pin 12-IC7400 on the LSP has raised to 1 V (0,6V). Check resistor R3408 (33k; 4822 051 10333). |