Dicas Reparação PHILIPS





Pesquisa: PHILIPS

Resultados 13482

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
PhilipsFL1.10Low frequency hum from subwoofer, buzz from right hand squeeter.Check DC level on pin 1 and 9 of IC7011 (TDA1521). If not correct, replace (4822 209 63913).
PhilipsFL1.10Low Brightness TXT and OSD, Picture OKIf this condition occurs, check the Option Codes. Resetting the Option Code numbers as per the Service Manual provided the cure.
PhilipsFL1.10JitterIn PIP unit change the value of R3336 to 4k7.
PhilipsFL1.10How to enable/disable "Child Lock"Press "MENU" button on Remote Control. When the menu appears on the screen, you select "SPECIAL FEATURES" (this expression is language dependent) Within "SPECIAL FEATURES", the "CHILD LOCK" can be enabled or disabled.
PhilipsFL1.10Horizontal oscillator not stable.For a more stable adjustment of the horizontal oscillator change the next items on the Large Signal Panel: position 3405 from 30k into 33k ohm (4822 051 10333) position 3406 from 10k into 4k7 ohm (4822 100 11319) REMARKS : Introduced in producti
PhilipsFL1.10Goes to st/by at sw on & chan change - pic too bigHT high at 156v (141v), R3374 75k had increased in value
PhilipsFL1.10Four dark bars over the picture.The +5 volt was 5.6 volt instead of 5.1 volt. Check/replace IC7551 (4822 209 70672).
PhilipsFL1.10Fault GuideSee TV Mag Nov 2000
PhilipsFL1.10Fall off position 3204 on the Large signal panelFall off position 3204 on the Large signal panel ------------------------------------------------ When position 3204 (NTC/PTC; 4822 116 40215) on the LSP is defect it is recommended to replace it by a PTC/PTC (4822 116 40253). Together with this change al
PhilipsFL1.10Dead - no volts to mains capPositor PH95315 & fuse
PhilipsFL1.10Dark picture, only green led, no menu or OSD.+5V supply was 4,1V. Voltage D6551 was 4,3V instead of 5,6V. Check/replace D6551 (4822 130 80954).
PhilipsFL1.10Crazy behaviour: No response from RC or controls.Other phenomenas: volume up/down, spontanuous service mode etc. etc. in areas with TOP-teletext. Replace control software by replacing EPROM IC7002 to version V82 (4822 900 10423). For easy mounting also the controlboard 7115 (on SSP) can be replaced by
PhilipsFL1.10Crazy behaviour: No response from RC or controls.Other phenomenas: volume up/down, spontanuous service mode etc. etc. in areas with TOP-teletext. Replace control software by replacing EPROM IC7002 to version V83 (4822 900 10506). For easy mounting also the controlboard 7115 (on SSP) can be replaced by
PhilipsFL1.10Correction to Product Survey 1996-4Correction to Product Survey 1996-4 (4822 727 21505) ---------------------------------------------------- On page PCS 41989 is mentioned at: FL1.10 AG11 and higher: Control panel 4822 212 31708 FL1.17 AG20 : Control panel 4822 212 31708 FL
PhilipsFL1.10Colors flicker when the set is warm or poor colorsCheck IC7366 color signal delay circuit (TDA4660). Replace by TDA4661 (4822 209 31714). When TDA4660 is replaced by TDA4661 also change the following components: - delete 2386, 3385 - change 3383 into 33k (4822 051 10333) - c



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads