Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | CP90 | Audible hum in standby mode | A production change has been introduced increasing the value of C2661 from 33nF to 100nF (code no. 4822 121 41689). | ||
Philips | CP90 | 95 volt varying with contrast level. | Check/Replace D6665 - 1N4148 (4822 130 33939), R3665 - 4.7 Ohm safety (4822 111 30499). | ||
Philips | CP110 Mk2 | Dead set aft an hour or two | F1653 1.6A wickman fuse o/c on separate overvolts trip panel - caused by CNX62 opto coupler | ||
Philips | CP110 27CE3291/15B | No blue | IC 7260 TDA 3562A . Also replaced 2408 cap 6,8 uF 63Von crt pcb and cap 2633 100uF 25v | ||
Philips | CP110 25CE6570/05B | Display erratic - int shows E1 | Replace µP IC7840 (TMP47C432AP-8189) | ||
Philips | CP110 | WON'T GO BUT11AF TRYING TO WORK | D6672 ON SECONDARY SC | ||
Philips | CP110 | WON'T CHANGE CHANNELS FROM FRONT BUTTONS OR SOMETI | SWITCH MEMBRANE OR POSS CONNECTING SOCKET | ||
Philips | CP110 | Width - lack of - R3599 overheating. | C2613 ( 390nf ) o/c. | ||
Philips | CP110 | When switching to another transmitter the picture becomes blue. | R3049 an IF module was 270kohm becomes 330kohm. | ||
Philips | CP110 | When set is cold, lines are tearing out | Replace C2633 (100 uF 4822 124 20735) | ||
Philips | CP110 | Verticals rippling | C2633 100µ | ||
Philips | CP110 | Verticals ragged when cold | C2633 100µ 25v | ||
Philips | CP110 | Vertical lines, screaming psu & dark grey raster | D6067 3v9 zener leaky | ||
Philips | CP110 | Txt Flickering - Tuner drift | D6673 BYV95A 9v rect | ||
Philips | CP110 | Txt - letter at far right of each page faulty | UPD4364 ROM chip in Txt cct |