| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Philips | CP110 | CHANNEL DISPLAY GOES TO " E " | MICRO 7840 | ||
| Philips | CP110 | Chan display reverts to"E" | Micro 7840 faulty | ||
| Philips | CP110 | BUT11AF gets stuck in stand-by mode; BUT11AF gets hot. | Check the value of resistor R3659 (100 Ohm). The fault occurs when the resistor is open or when the value is increased. | ||
| Philips | CP110 | Brightness varying. | Check/replace D6401 (1N4148: 4822 130 33939) on CRT base PCB. | ||
| Philips | CP110 | BOTTOM OF RASTER MISSING | R3572 O/C 1R5 | ||
| Philips | CP110 | Blank screen - gives blue screen with fb lines when A1 advanced | Tr7405 BF423 on crt base s/c | ||
| Philips | CP110 | Blank raster with "E" in display | micro s/c to chassis | ||
| Philips | CP110 | At times no contrast. | Replace T7415 (BC556; 4822 130 40989). | ||
| Philips | CP110 | 3 Page layout with faults - Pic cover June 93 | For more faults see also CP90 most of chassis is the same. | ||
| Philips | CP110 | 140v RAIL LOW ( 60-70v ) | C2661 2200uF OC USE Philips PART ONLY | ||
| Philips | CP110 | 140 volt rail collapses after 5 minutes. | Replace standby switch transistor, T7739 - BC548 (4822 130 40938). | ||
| Philips | CP110 | 1 mm curl in vertical lines | Capacitance of capacitor C2633 100 uF (4822 124 41584) has decreased (dried). Capacitor C2670 22 uF (4822 124 22257) hot. | ||
| Philips | CP110 | "MEMORY LOSS" of one or two arbitrary programmes | Disconnect pin 34 of IC7840 from the +6 Volt. Add diode 1N4148 (4822 130 30621) between +6 Volt and pin 34 of IC7840 (with cathode to point 34 of IC7840). Add serie circuit of resistor 10 kOhm and capacitor 100 uF/10Volt (4822 124 40184) between +6 Vo | ||
| Philips | CP110 | "F1" displayed & Field collapse | Dry joint 12v reg IC7675 | ||
| Philips | Combi | Remote control not responding | Check not set to VCR2 - press Stop & 1 together or removing batts will restore VCR1 setting |