Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | ANUBIS-A | ANUBIS-A TXT with 3 local controls with uC TMP47C4 | ANUBIS-A TXT with 3 local controls with uC TMP47C434N-R133 (ANUBIS-A AC) Replaced by uC TMP47C434N-R165; 4822 209 33275 Hotel mode for uC TMP47C434N-R133: YES Hotel mode activation for uC TMP47C434N-R133: 1.Select program 38 2.Press simultaneously "ME | ||
Philips | ANUBIS-A | Anubis A option diode for 4 page TXT | Anubis A option diode for 4 page TXT ONLY FOR ANUBIS A AC In service information SI94.01 4822 727 20292 the text indication at option diode 6606 is wrong; it should be 4 page TXT. So the option diodes for Anubis A AC with latest software version R165 | ||
Philips | ANUBIS-A | All LEDs in display blinking. | Check LOT 5445 (4822 140 10406). | ||
Philips | ANUBIS-A | After a while no picture. Only sound. TXT and OSD are OK. | Check whether DC voltage pin 11 IC7280 (TDA3504) is 3V. If not, check/replace C2255 (100nF; 4822 122 33496). | ||
Philips | ANUBIS-A | AFC control is slowly. Station unstable. | Check tuner (UV917/IEC; 4822 210 10405). | ||
Philips | ANUBIS-A | 50 Hz humm at loudspeakers in stand-by | In case of a 50 Hz humm at the loudspeaker in stand-by of a 3W Anubis A set, it is recommended to replace: SOPS transformer 4822 148 60299 (dedicated for 3W Anubis A sets) at itemnumber 5525. REMARKS: The ripple of the +13 supply voltage coming from the | ||
Philips | ANUBIS-A | + 95V is too low. | Check/replace TS7445 (BUT11AF;4822 130 42679). | ||
Philips | Anubis B-AA | When replacing EEPROM IC7685 ST24C02P | Default language is Norwegian! & childlock (Barnlas)active. To clear childlock select spec functs option C on main menu. Next menu - Barnlas as option A - set to Fran (off). Then able to set up other parameters | ||
Philips | Anubis B-AA | Removing "Demo" mode | Switch on whilst holding in "VOL-" & "Prog+" in together. | ||
Philips | Anubis B-AA | LED flashing with "ER4" displayed | Fault in Txt - lines only in Txt - Xtal 1701 27Mhz faulty | ||
Philips | Anubis B-AA | Hor grey line over pic | Field scan has osc on it - C4213 10nF o/c | ||
Philips | Anubis BAA | Dead with pulsing squeak | C2540 2200µ 16v leaky | ||
Philips | Anubis B AA | Dead - chopper tr s/c | Replaced opto IC7514 CNR50, Control chip IC7500 & chopper tr | ||
Philips | Anubis B | WORKS BUT LED FLASHES AND E4 ON SCREEN + NO TEXT | 27mhz XTAL ON TEXT PCB | ||
Philips | Anubis B | no txt | 27Mhx xtal |