Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | 32PW9765 | Pumping effect (horizontaly) of the picture | Pumping effect (horizontaly) of the picture during picture changes from low to high luminance Implement a high voltage bleeder in the set on the following way: Modifications on the Large Signal Panel: Change position C2448 into 10nF (4822 121 41857) | ||
Philips | 32PW9763/05 MD2.25E | St/by only with led flashing | Main micro on control board pin 53 stuck hi due to D6227 zener 3v3 sm o/c. For more info see TV mag Nov 2001 | ||
Philips | 32PW9611/58 | Green LED comes on at sw on briefly then reverts to red led (St/by) with no 140v at +A | full wave bridge rects all s/c & safety res 2r7 15w. The chopper mosfet, with strange markings was also s/c type :G239-1HEX fitted a IRF PC 50 rated at 11amp. In lieu | ||
Philips | 32PW9544/05M | Dead with flashing LED | St/by relay - can swap this one with degauss one for test purposes pt no 4822 280 10375 | ||
Philips | 32PW9525 | Pumping effect (horizontaly) of the picture | Pumping effect (horizontaly) of the picture during picture changes from low to high luminance Implement a high voltage bleeder in the set on the following way: Modifications on the Large Signal Panel: Change position C2448 into 10nF (4822 121 41857) | ||
Philips | 32PW6515/05 SA10E | Hum from front speaker | Remove link 9710 & connect link from 9710 (C2702 end) to link 9278 | ||
Philips | 32PW6332 | Service mode adjustments | Short pins S42 & S43 on signals board (upright board on L). Now have various options available | ||
Philips | 32PW6332 | No sound | Enter service mode & check option NI (Nicam) - should be "Y" (yes) next to it | ||
Philips | 32PW6005/05 SA10E | St/by only | Resolder SMD TDA8885, it is located on the sub-board next to the tuner.(Runs very hot) | ||
Philips | 32PW6005 | Set inoperative and PTC defective. | Check and replace if necessary position 3912 on the large signal panel by 4822 116 10105 IRIS CODE : M11X | ||
Philips | 320 Mono | No picture. | C2207 , T2828. | ||
Philips | 31DV3 | Not recording Sound | The cause of this fault was traced to 3230, the resistor had gone high. The resistor had changed from 2k7 to 4k3. | ||
Philips | 31DV3 | Intermittent loss of picture and sound, teletext also affected | Check EPROM on the teletext PCB. Check IC 7751 (KSTX1), might be faulty when warm. | ||
Philips | 31DV3 | Change of threaded in time after rewind | After rewind to tape begin, the above VCRs go to the threaded in position. If no function is requested, after 6 minutes the VCR dethreads to the stop position where it stays for 2 minutes before returning to standby. From week 41 the waiting time at th | ||
Philips | 2B 28CT8890/79R | White screen with normal sound | C2638 4µ7 350v in RGB o/p supply |