Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | 20PV164 | cuts out after 10 mins | replace frame IC 6510 (4822 209 13066), D6513 (4822 130 30842) and C2513 (4822 124 11539) | ||
Philips | 20PT138A | Dead | R3450 3R9 (to 5v5 supply rectifier off loptx) | ||
Philips | 20HT3303 | Service code of the FM-Radio tuner. | In the partslist of the Radio-SP/LS-Vbatt panel of the Chassis Manual L9H.2E, the service code of the FM-Radio tuner item 1901 was not indicated. The service code is 9352 632 70112 | ||
Philips | 20HT3303 | "welcome message" doesn't come up at start up. | When the set is switched off via the mains switch and is switched on again after more than 5 minutes, the "welcome message" doesn't come up at start up. Put the set into the SDM mode. Select the option AS (Auto start-up). Change the option content fr | ||
Philips | 20DV1 | Replacing the combi head | After replacing the combi head the setting of the head height is referred to in Section 2:8:4 of the IDM deck manual. The method used is to set for maximum amplitude of the control track signal. In the above mentioned VCRs the signal is amplified in a lim | ||
Philips | 20DV1 | Production change | In VCRs from WD32 onwards coil 5005 on the family board (jfb) will be replaced by a fuse. The fuse is given the position no. 1005. The fuse rating is 250mA/125 volt. The code no. of the fuse is 4822 252 51142. IMPORTANT: The fuse becomes a safety c | ||
Philips | 20DV1 | Poor response to Infra Red Handset operation | It is possible that VCRs of the above types and having a week code of 9042 or 9043 may not always respond to signals from the remote control handset. Cause:A small number of capacitors fitted in position numbers 2021 and 2022 on the operating panel (JDC) | ||
Philips | 20CT4626/05T | Cracking & banging. | Drys on LOPTX. | ||
Philips | 17PT165B AA5AB | Dead aft lightening strike | Replace 1571 (630mA wickman) and retune stations (tuning memory had been wiped out). | ||
Philips | 17PT161A | To adj tuning | Dedicated R/C reqd pt no 4822 218 21249 & must press both diamond keys together to enter tuning mode | ||
Philips | 17HT5403 | To adj sound level of this "Hotel" TV | Press Set Up then "M" then scroll down options to vol - adj vol then press "M" | ||
Philips | 17CE1358/05B | No col | TDA2541 faulty - (pin 26 TDA3561A = 2.2v NOT 10v as marked on cct) | ||
Philips | 14VP274/05 | SOUND OK NO PICTURE | IF NO HEATERS REPLACE R3532/3537 AT REAR OF TV PCB BOTH 4R7 FUSIBLE | ||
Philips | 14VP184 | DEAD, BLOWING FUSE | REPLACE POSISTOR | ||
Philips | 14VP163 | WHITE RASTER WITH FLYBACK LINES THEN STANDBY | REPLACE R3592 |