Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Philips | 14PV263 | Codenumber correction | The codenumber for the scanner-motor (POS. 34) in the Service Manual is wrong. The correct codenumber is 4822 361 215 48. | ||
Philips | 14PV263 | Codenumber correction | The codenumber of pos. 1701 (tuner) for 14 inch sets with IEC input is 4822 210 10691 (UV916S). | ||
Philips | 14PV263 | Calling installation menu | The installation menu is activated by the following procedure: - switch on the set by means of the stop key. - Press simutaneously the cursor left and the cursor right key on the remote control. | ||
Philips | 14PV210 | No pic; R3199 burnt | R3199 (9K2) and D6183 (SMD) Used 1N4148 in lieu | ||
Philips | 14PV210 | Fault codes | record led flashing >>>error in eeprom1[ic7818]; timer led flashing>>> error in eeprom2[ic7801]; stdby led flashing>>> error in textmicro[ic7804] | ||
Philips | 14PV202/07 | Int blows fuse at sw on | Replace degauss coil, degauss posistor and 1.25 amp fuse | ||
Philips | 14PV200/07 | Dead apart from popping sound at sw on | D6391 BYW98 200 rated at 3A s/c - used BY399 in lieu | ||
Philips | 14PV200/07 | "N ACT" shows at sw on | Switch the combi off with the mains switch. depress and hold both the wind & rew buttons on the combi while switching back on (Keeping the buttons pressed for around 5 seconds) Release the buttons and this should clear the memory and allow the combi to be setup as normal | ||
Philips | 14PV184 | Reverts to st/by at sw on aft LOPTx replacement (LED goes from brief green to red) | Eventually comes on with dull grey raster. PROT line on micro IC7801 pin 53 vcr pcb only 1v (5v) - check at D6568 LH plug 1923 - prot Tr 7550 BC547 leaky (front left edge of tv pcb) | ||
Philips | 14PV184 | Menus not displayed | L1802 on bottom panel across pins 42 & 43 of micro IC7801 | ||
Philips | 14PV183etc | Service mode adjustments | Press "STOP" on handset & "PLAY" on keyboard together for 5 secs | ||
Philips | 14PV183etc | No Chan +/- on R/C after EEPROM replacement | Enter service mode & set correct option number - to be found on back plate of set | ||
Philips | 14PV183etc | Hotel mode activate/deactivate | Press "STOP" on handset & "STOP" on keyboard together for 5 secs whilst on Chan 38 | ||
Philips | 14PV183 | To enter service mode | Press "Stop" on r/c & "Play" on k.board for 5 secs | ||
Philips | 14PV183 | To activate/deactivate "hotel mode" | Press "Stop" on r/c & "Stop" on keyboard for 5 secs whilst on Ch 38 |