Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Panasonic | Euro 2 | Excess width & no E-W corr | Q593 BC547B | ||
Panasonic | Euro 2 | E-W fault | Q593 BC547B | ||
Panasonic | Euro 2 | Entering service mode | First set the Bass to max. & the Treble to min. Next press the "REVEAL" key on remote & at the same time the "PROGRAM DOWN" button on the TV. Using the Red & Green buttons on the remote one can step through the electronic screw driver adjustments using the yellow & blue button to adjust settings. Switching the receiver off stores the settings in the EPROM's. | ||
Panasonic | Euro 2 | Dead - mains fuse blown | Positor arcing internally | ||
Panasonic | Euro 2 | Dark vertical bars down magenta areas of pic | I1601 VDP3108-25 on board A | ||
Panasonic | Euro 2 | contrast breaking up/ lines across pic | sm C310 0.1µ - Volts at coll of Q311 only 3.8v instead of 11v | ||
Panasonic | Euro 2 | Bright raster with fb lines then off | R378 3.3k. & R366 going OC on crt base & R366 100R safety res o/c | ||
Panasonic | Euro 2 | Blank bright raster with fb lines | R378 3k3 & R366 100R o/c on crt base | ||
Panasonic | Euro 2 | Black diagonal lines across pic int & int cuts out | IC1701 TPU3040-18 Txt proc chip | ||
Panasonic | Euro 2 | All Euro-2 chassis televisions with vertical jitter after changing IC601 | The original digital video-processor IC601 has been discontinued by the supplier, so we now supply a kit part number TZS9EK002-2, which includes an EEPROM with the neccessary software changes to use a VDP3108APPA1 digital video processor without experiencing vertical jitter. Some original Euro-2 sets having the suffix M will already have this processor fitted and so do not require the re-written EEPROM. Sets affected are TX21MD1, TX21AD2, TX25MD1, TX28LD1, TX25AD1, TX25AD1DP, TX29AD1, & TX29AD1DP | ||
Panasonic | Euro 1 TX29A3 | Reverts to st/by aft 10 secs of EHT & sound but no pic | Fit fop kit (TZS5EK001) & check o/c 1R5 (R561) resistor. | ||
Panasonic | Euro 1 TX28W3 | Service mode entering | In audio menu, bass max/treble min, then press vol down on TV & TEXT REVEAL on hset. Use red & green to select, yellow & blue to adjust - store on TV | ||
Panasonic | Euro 1 TX28W3 | Dead - no o/p from psu - pri 300v only | Check R628 470k, R626/627 560k, C622 100µ 25v & IC611 TDA4601 | ||
Panasonic | Euro 1 TX25A3 | St/by LED flashes slowly & volt supplies slightly high | Flexi ribbon cable in front control panel cleaned | ||
Panasonic | Euro 1 | YELLOW PIC NO BLUE | R3374 100k |