Dicas Reparação SANYO




Modelo - Chassis


Pesquisa: SANYO Enviar Dica Resolvida
Resultados 689
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SanyoCBP3001
Lines over pic & bent vertsC421 1000µ faulty - decoupler for IC201 supply pin 6
SanyoCBP2876-00 ED028
Txt moves sideways - pic okIC400 DPU2553 & check for line pulses to the chip
SanyoCBP2876 ED0 series
Field collapse with thin bowed line across screenBad joints CRT coil connector
SanyoCBP2876 ED series
Dead - LOPTr s/cdry joints on the Q600 a TIP111 Darlington device, C606 2.2mfd 50 volts C605 located next to TIP111 which was leaking electrolyte, T600 the line driver TX which was short circuit to all legs having cooked up and R600 10 safety resistor which feeds the line drive stage from the 28 volts rail coming from the PSU.
SanyoCBP2876
St/by only with squealingfop chip TDA8170, C703 100µ, Fuselink R715 replaced & now works with hissing from LOPTx. LOPTx also replaced
SanyoCBP2876
Red, green & blue flyback linesC700 100µ hi esr
SanyoCBP2872 ED1
No sound when sw on if still warmIC560 ADC2301E on sigs panel pt no 409 211 9404
SanyoCBP2872 ED1
No sound - comes on briefly when cold sometimes with crackle/hissOK from scart socket - IC561 APU2471 could be faulty
SanyoCBP2872 ED1
Lines when cold with shading as warms upC404 (100mfd 50v) in the frame stage was the culprit, although its ESR reading was OK, and there were no signs of leakage
SanyoCBP2872
REPEAT FAIL OF LOP TR ( 2SD1555 )IC DPU2553
SanyoCBP2872
No sound from spkrs - ok from scartIC561 APU2471 on sigs panel
SanyoCBP2866
Int trip/blank raster/no field syncIC780 12v reg - use TIP41 & 13v zener & 27v dropper as reg nla
SanyoCBP2865 E3A28
Picture and sound goes off int.12v Reg IC780 failed when hot.
SanyoCBP2865 E3
Int sound/pic with bright white raster with low height or field collapse reverting to st/byIC780 SI3122V 12v reg s/c internally when heated
SanyoCBP2865
INT BRIGHT RASTER WITH REDUCED HEIGHTREPLACE IC780 12V REGULATOR


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads