Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
Sanyo | CBP2580A EB2 series | Tripping - even with psu on dummy load | black jumper wire which runs from the earth side of the chopper transformer to a point very close to IC351 a regulator IC, was dry jointed at the chopper transformer end. | ||
Sanyo | CBP2580 EB125 | This set would shut down interrnittently: the peri | The set could be made to run indefinitely by entering the service mode ( menu on the set's control panel , followed by menu on | ||
Sanyo | CBP2580 EB1 | To enter service mode | Menu on set's control panel, followed by menu on R/C handset | ||
Sanyo | CBP2580 EB1 | Shuts down int - runs ok in service mode if IM bus run is stopped | Fault somewhere on the IM bus - NVM3060 EEPROM on digiboard cured fault | ||
Sanyo | CBP2580 EB1 | Colour lost & pic shifted to right when heated | Xtal X403 pt no 610 217 1037 | ||
Sanyo | CBP2580 EB1 | AFTER 2-3 Hrs COLOUR GOES AND PICTURE SHIFTS TO R | XTAL X403 DRIFTING Pt No 610 217 1037 | ||
Sanyo | CBP2580 | St/by only - trips at start up | 22mfd 250v B+ decoupler s/c | ||
Sanyo | CBP2580 | Int start up - EHT can be heard | Check for int mains switch | ||
Sanyo | CBP2576A/00 | Bright blue raster with fb lines | IC500 which is a TEA5101A on the crt base pcb. R534 22 ohm was ok. | ||
Sanyo | CBP2576A ED0 chassis | No raster | TEA5101A RGB chip | ||
Sanyo | CBP2576A ED0 chassis | Height twitches, int bright raster with fb lines | Resolder conns on digital panel | ||
Sanyo | CBP2576A | Field top foldover & excess height | C703 100µ 50v | ||
Sanyo | CBP2576 ED0 | No sound | Carry out "start NVM" proc as described in manual | ||
Sanyo | CBP2576 ED0 | No E-W correction | ICP R756 (N20) o/c | ||
Sanyo | CBP2576 ED0 | Dead - whistle only - LOPTr 2SD1556 leaky | ,Overheats when replaced with int narrow pic, replaced C750 47µ 50v & C705 2µ2 50v for hi esr & check for dry joints in LOP section |