Dicas Reparação SHARP
Modelo - Chassis
Pesquisa: SHARP Enviar Dica Resolvida
Resultados 1459
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| SHARP | 20R12 20S02 | Apenas nos canais altos apresenta saturação de vídeo quando se tem imagem branca ou mais clara, distorsendo e/ou riscando nas partes brancas. | C659 | ||
| Sharp | C2015P | Vertical line in the middle of screen. Vertical IC defective. Type: X0238CE | Replace with a common uPC 1378. (Fully compatible) | ||
| Sharp | VT3700H | Won't tune. | IC1005 , R760 IC1005 Sharp RH-IX0249CEZZ R760 220ohm , Sharp VRG-RF2EB221J | ||
| Sharp | VT3700H | St/by only | L752 burnt up - replace all smis in the line concerned | ||
| Sharp | VT3700H | Off tune on timer recs | VT supply to tuner rises when tV in st/by - IC005 33v stab RH-IZ0249CEZZJ | ||
| Sharp | VT3700 | No sound/pic - tape stuck in | R761 1R fusible o/c, Zener D757 15v s/c, L752 o/c & check ck caps in psu | ||
| Sharp | VT-2198B | unable to reduce vol to min - OSD OK | R1090 12k 0.25w on daughter pcb | ||
| Sharp | SV287XH | St/by only at sw on with burning smell | R518 2R2 smokes due to fop chip IC501 LA7831 faulty - caused by C521 & 522 100µ 35v o/c | ||
| Sharp | SV287XH | Blank raster/no sound - OSD present (RF & Scart) | Switching [video and audio] is performed by IC401 [M51321P] a three gang three way device. pin 15 of the IC works on a tristate level. With the IC supply being 12V: 0 - 2.5V Input from BNC; 5 - 7V Input from scart ;9 - 12V Input from tuner. Diode D419 [DX00458M] which links to the wiper of the AGC preset was leaky, limiting the voltage on pin 15 to 7V and thus preventing tuner mode selection. Replace D419 with an IN4148 | ||
| Sharp | SV2589 | Red tint at top of pic & slight vert jitter | C636 330µ dy joints | ||
| Sharp | SV2589 | INT RED TINT IN TOP 2/3rds OF PICTURE | C636 DRY CHECK DIODES ON HEATSINK ALSO | ||
| Sharp | SV2589 | For PSU problems. | Resolder diodes attached to PSU heatsink. | ||
| Sharp | SV2588H | Dead aft brief activity at sw on | Overiding relay gave blank raster/no sound - D712 & D713 dry joints | ||
| Sharp | SV2142ED | Hi HT at 250v (115v) | Crack in print by pins 1 & 4 of STRD5441 | ||
| Sharp | S3B DV5131H | coloured lines on top | C712 100uF 35V |