Dicas Reparação SHARP
Modelo - Chassis
Pesquisa: SHARP Enviar Dica Resolvida
Resultados 1459
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sharp | 5BSA 51AT15H | not stopping in tuning, pic distorted | corrupted EEPROM, enter service mode and set AFT to 9F | ||
| Sharp | 5BSA 51AT15H | no teletext | IC1001 SDA5254 (RHIX1578BMN1) | ||
| Sharp | 5BSA 51AT15H | No sound/pic & all o/p volts a third down | Q509/510 in fop s/c | ||
| Sharp | 5BSA 51AT15H | No sound/pic - goes to st/by aft 30 secs | C604/C622 220µ in line dr cct (not C804/822) | ||
| Sharp | 5BSA 51AT15H | No green | Enter service mode (V-, P+ & mains on) to check setting - was set to zero | ||
| Sharp | 5BSA 51AT15H | LOPTr runs hot and goes s/c | replace Q602 RHTX0118BMZZ (LOPTr Q601 part no RHTX0132BMZZ) | ||
| Sharp | 5BSA 51AT15H | Lines/chopper tfmr sqealing | C804 & C822 220µ in line driver stage | ||
| Sharp | 5BSA 51AT15H | LED pulsing, lack of frame. Intermittent | C713 1000uF leaky and Q509 (RHTX0108BMZZ) leaky B/C | ||
| SHARP | 5BSA 51AT15H | LACK OF HEIGHT WITH PATTERN ON SCREEN | REPLACE C713 1000MFD | ||
| Sharp | 5BSA 51AT15H | lack of height and patterning on the screen | C713 1000uF | ||
| Sharp | 5BSA 51AT15H | Int off with screeching causing corruption of AGC & AFC memory settings | Q708 BC338-40 in sw5v - used BD131 as higher powered replacement | ||
| Sharp | 5BSA 51AT15H | Int loss sound and/or colour for 1sec . | Change C209 from 1uF to 100nF 50v Pt No VCEAGA1HW104M , C808 from 100nF to 47nF 50v Pt No VCKYTV1HB473K ( use only Sharp part | ||
| Sharp | 5BSA 51AT15H | Int cuts out | HT ok, 5volt supply +5Vb low Q708 BC338-40 u/s | ||
| Sharp | 5BSA 51AT15H | HT high at 114v (105v) & EHT varying (can blow BU508DFI (don't fit BU508DF) | ZD717 & 718, Q708 (7v supply) faulty | ||
| Sharp | 5BSA 51AT15H | Green LED flashes and dim - no sound/pic | HT = 113v (should be 105v); Q708 (BC338-40) and D715 (5v1 zener). |