Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18944
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | HVL80D | PART AVAILABILITY FOR FRONT HOUSING | Underwater camera light turns on in transporting of unit.Heat generated from light melts front housing. Front housing part is notavailable (see S/B 22). The need for this part exists. | ||
| Sony | SL2410 | CAPSTAN SPEED AND PHASE DO NOT LOCK | In BII the picture has noise bars and the audio is unstable.TP11 on the (SS-13) board should have a 50% duty cycle. The waveform isdistorted with a series of negative pulses. The waveform at TP9 is ok. | ||
| Sony | EVC8U | SERVO SPEEDS UP WHEN PAUSE IS RELEASED | The capstan servo speeds up when pause is released thensettles to normal play. | ||
| Sony | PCM501 | STATIC IS HEAD ON AUDIO OUT | Static or distortion is heard on the audio out. | ||
| Sony | CFSW501 | 10KHZ NOISE IN HIGH SPEED DUBBING | A 10KHz noise is heard only in high speed dubbing. All otherRecord, Playback functions ok. | ||
| Sony | CPD1303 | FLAGGING AT TOP OF SCREEN WHEN USED WITH MAC II | After about one hour of operation, a flagging would start attop of screen when used with MAC II. This problem would not be seen withmultiscan generator at Macintosh II frequency. | ||
| Sony | CPD1302 | FLAGGING AT TOP OF SCREEN WHEN USED WITH MAC II | After about one hour of operation, a flagging would start attop of screen when used with MAC II. This problem would not be seen withmultiscan generator at Macintosh II frequency. | ||
| Sony | SPP150 | HANDSET NOT RECEIVING I.D. CODE | Handset not receiving I.D. code when placed on base unit.Power LED on base continues to flash, no communication between handset andbase. By hard-wiring from where I.D. transmission exits (mini-chargeterminals) to where I.D. code enters handset, proved I | ||
| Sony | SPP110 | HANDSET NOT RECEIVING I.D. CODE | Handset not receiving I.D. code when placed on base unit.Power LED on base continues to flash, no communication between handset andbase. By hard-wiring from where I.D. transmission exits (mini-chargeterminals) to where I.D. code enters handset, proved I | ||
| Sony | CDP350 | DRAWER CLOSED BUT NO FOCUS SEARCH - THEN UNIT EJECTS DISC | The drawer is closed but no focus search then the unit ejectsdisc. | ||
| Sony | STRAV1000 | SWITCHES DO NOT WORK ON FRONT PANEL - REMOTE OK | Power switch, tape mon. switch, EQ defeat switch and othersnot working on front panel. Remote is ok. | ||
| Sony | WMD6C | NO PLAYBACK | No playback. Replaced dolby IC-101 and 201. Still dead.Found shorted C-138. | ||
| Sony | WMD6C | NO RECORD, RIGHT CHANNEL PLAYBACK OK | No record, right channel playback was ok. Waveform at bothhead leads showed virtually identical bias and audio waveforms. Head waschanged. Switched head wires. Problem remained in same channel. Finallykilled bias oscillator and looked at head input | ||
| Sony | STRVX550 | NO CONTROL OF VOLUME, BASS, TREMBLE AND INPUT SWITCHING | Volume was at one set level and would not change. Displaywould change. Also all inputs were being passed through the ASP chip andswitching would not switch the ASP chip. ASP chip had been changed withno success. We had data circuit and strobe into IC | ||
| Sony | D15 | (ENTER/REMAIN) SWITCH DOES NOT FUNCTION | Enter/Remain switch does not function. This problem has alsobeen verified in three other units with unrelated serial numbers. |