Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18938
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCFSF11
JAMMED DECK Head gear P/N 3-313-754-01 broke jamming deck. Afterreplacing gear, and replacing ball's back under head table, in RWD orREV mode head table does not come up enough to lock in position. With nodisassembly instructions unit cannot be serviced successful
SonyCDP200
DISTORTION AT OUTPUT Went through alignment procedure, but found gross distortionin audio output. Noticed that waveform at Pin 1 IC506 and IC507 was blankfor a portion of the charging time. Could not find any voltages or wave-forms around IC505 wrong.
SonyCDP200
JAMMED GEARS ON CHUCKING MOTOR Thrust play on chucking motor was excessive causing gears tojam. The limit switch (S805) did not close until cam chucking plate 60was at the mechanical end of its travel. This caused the motor tocontinue to run for a short time after mechanical movemen
SonyCDP101
PLL OUT OF SPECIFICATION Disc motor turned backward at maximum speed as soon asturning on the power switch. There was no 1/4 RFCK at Pin 23 of IC210(CX193).
SonyCDP101
UNIT WOULD NOT RESPOND TO REMOTE CONTROL Remote control RM101 would not work with this unit. Did nothave another hand unit to try. By repeatedly keying unit and examiningwaveform at base of Q1, we determined that product word code being outputwas wrong. For example 10011 instead of 10001.
SonyWA33
MALFUNCTIONING MOTOR Motor speed will vary after unit runs about 30 minutes.
SonyTCK555
GROUND SHORT The left channel looses record amplitude intermittently.The ground shield between the record and playback boards shorts againstRV301, the left channel record level control.
SonyTCFX30
ERROR IN S/M In the schematic section (Pages 24B, 25 of both manuals)R321 and R322 are mislabelled as R332, R321 respectively. Also a missingconnection line exists in both service manuals. It is located to theleft of the mislabelled resistors. -HQ COMMENTS: The sc
SonyTAYX7F
MISSING PART # IN MANUAL The servicer needs to replace the volume control motor inthis unit. There is no part or even ref. number listed in the manual. -HQ COMMENTS: 1) Checked with NPC/KC and found the motor and thevolume control comes as an assy. Order the part by the numbe
SonySTRVX5
PART # ERROR IN MANUAL Receiver was dead. Checked inside and found PPS had nooutput. Inverters were changed, still no output. T902 was jumpered andstart ckt was checked, waveform was OK. Further eyeball inspectionrevealed C905 was split. -HQ COMMENTS: Please order the cap
SonySTR4800SD
MISSING PART # A servicer asked the part # for the FM front end (FAF-033W).It is not listed in the S/M.
SonyNR500
ERROR IN MANUAL Incorrect cal. indicator adjustment procedure. See Page 10,Section 3 Adjustments is also error in schematic (Pages 15/16/17) - D314.Left and right audio channels are shorted together at C133 and C233.
SonyMTL10
CAM GEAR OUT OF POSITION Several units did not work out of the box. The problem isthat the main cam gear is not properly positioned. Repositioning the camresolves the problem. -HQ COMMENTS: The main cam gear being out of position may have beencaused by some irregular cassette
SonyCFSF11
PART NUMBER FOR SPLIT GEAR Found split gear on bracket assy head (#424) on two units.I would like separate part # for gear, or is it included in bracket assypart # X-3313-714-0? -HQ COMMENTS: The gear is available separately. The part # is3-313-754-01. Please refer to the T/N
SonyWM7
HEAD BRACKET OUT OF POSITION 1) No audio, noise only. 2) Low volume, audio distorted.3) Low audio, low volume, high pitch noise.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads