Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
Sony | SPPQ210 | NO PAGE BUTTON ON BASE BOARD | Cannot put base in test mode as there is no page button inbase board. | ||
Sony | SPPQ210 | NO DIAL TONE - REPLACE HANDSET SPEAKER SP501 (150426121) | No dial tone, can't hear people. | ||
Sony | SPPQ200 | NO PAGE BUTTON ON BASE BOARD | Cannot put base in test mode as there is no page button inbase board. | ||
Sony | SPPQ105 | NO PAGE BUTTON ON BASE BOARD | Cannot put base in test mode as there is no page button inbase board. | ||
Sony | SPPQ100 | NO PAGE BUTTON ON BASE BOARD | Cannot put base in test mode as there is no page button inbase board. | ||
Sony | SPPA5000 | NO DIAL TONE - REPLACE IC304 IN BASE, P/N 8-759-824-20 | Won't get a dial tone. | ||
Sony | SPPA5000 | RX SINAD FAILING ON JIG ON MANY UNITS | Found RX sinad failing on jig at 13.9 db on base unit on alot of units. Could these coils be misadjusted at the factory. | ||
Sony | SPPA450 | POOR RANGE OR DOES NOT GRAB LINE - REPLACE Q1 IN BASE' | Unit had very poor range. Output of Q1 (RF amp/mixer inbase) was low. | ||
Sony | SPPA450 | NO POWER OR TEST MODE ON HANDSET | No power handset. Checked pins 31, 32, 34 on IC505 found pin31 low. Lifted pin and stayed low. Have seen this on a number ofSPPA250 and 450 units. One of four pins has been stuck low when problemoccurs. Problem may also exist on the new Q models. | ||
Sony | SPPA40 | MICROPHONE INCORRECT FOR HANDSET (NO PART # FOR BOARD) | MK651 microphone is too large for handset. Also, small board where mike is located has no part #. | ||
Sony | SPPA250 | NO POWER OR TEST MODE ON HANDSET | No power handset. Checked pins 31, 32, 34 on IC505 found pin31 low. Lifted pin and stayed low. Have seen this on a number ofSPPA250 and 450 units. One of four pins has been stuck low when problemoccurs. Problem may also exist on the new Q models. | ||
Sony | SPPA20 | UNIT WOULD NOT DIAL DIGITS 3, 5, 6, 9 - REPLACE X1 | Would not tone dial numbers 3,5,6,9. Adjusted rx level andgot numbers 5,9 to work but 3, 6 still did not work. Found rx vco freqway off. | ||
Sony | SPP62 | SERIAL NUMBER RANGE FOR MOD | The serial number range for phones mod 100,001 to 111,503. Have had many units above 111,503 that have C54 still in unit EX 200314,352736, 325003, 220976, 212916, 160518, 146915, 146102, 142206, 140967,127910, 186598. | ||
Sony | SPP2010 | UNIT DOES NOT DIAL, NO DIAL TONE - REPLACE IC503 | Doesn't dial, no dial tone. | ||
Sony | SCPH1001 | INTERMITTENT POWER/INTERNAL SPARKING OR BURNING | Sparks coming from inside unit near ac in jack. Found solderconnection broken at jack. 2nd unit I've seen with this problem. |