Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18944
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | SATA1 | CAN'T GET SATELLITE SIGNAL | I can't get the satllite signal? - SOLUTION: Use the zip code method to determine azimuth and elevation(make sure the system is connected and plugged in). You'll have to use acompass to judge the azimuth. You can use the hash marks on the dish tojud | ||
| Sony | SATA1 | WHERE IS DISH PRODUCED?/TENNESSEE | Where is the dish produced? -Answer: Tennessee. | ||
| Sony | SAT1 | USING VCR'S WITH CABLE MOUSE AND CONTROL-S | Can the latest Sony VCR's with cable mouse and control-s beused to change channels via the control-s on the DSS to record multipleevents on the VCR? | ||
| Sony | SAATB1 | DISH LOCATION TO RECEIVER | How far away should the dish be from the receiver? | ||
| Sony | SAATA1 | WATCHING C BAND CHANNELS | Can I watch my C band channels on this system? | ||
| Sony | KV9PT20 | FLAGGING AT TOP ON TAPES, R222 CHANGED VALUE | Flagging at top of CRT when playing back tapes on a VCR. Found VCC on IC201/pin 30 was very low. | ||
| Sony | KV32XBR96S | INTERMITTENT SHUT DOWN, REPLACE T503 HDT | The unit would intermittently shut down. The problem was caused by T503/horiz drive transformer. One of the legs on the primary side came loose and was making intermittent connection. Replacement resolved problem. -HQ | ||
| Sony | KV32XBR90S | THIN YELLOW LINE (V) IN THE MIDDLE OF PIX, COMB FILTER | Thin Yellow line in middle of picture. Adjusted focus andscreen controls. CRT checked ok. | ||
| Sony | KV32XBR36 | DEAD SET, T501 | Set would turn on make an arcing noise and shut off. Had tobe unplugged from outlet before it could be turned on again. All B+lines fed from G board checked good. No shorted or leaky componentsfound with ohmeter test. | ||
| Sony | KV32V16 | VERTICAL JITTERS, RE-DRESSED LEAD WIRES | Vertical jitters, pix jumps. | ||
| Sony | KV32V16 | NO POWER, IC101 | No power, unit dead. Standby and reset 5 volts ok. | ||
| Sony | KV27V15 | POWER BUT NO PICTURE, REPLACE R034 | Power on, but no Video/Audio, timer LED is blinking, no OSD. All DC voltages are ok, but no vertical drive and no video, chroma or audio on set. | ||
| Sony | KV27TS36 | INCORRECT PART NUMBER OF D BOARD, NPC SUBSITITUTION | Servicer ordered replacement board A1346129A for KV-27TS36, but it was National Back order. NPC shipped A1346192A(KV27V10) for replacement. However, unit does not work. They found 5V line is causing this. -HQ COMMENTS: | ||
| Sony | KV20VM20 | NO RECEPTION CABLE CONNECTOR (JACK) BROKEN | Customer reported TV had snowy picture. Found F connectorjack turned and was loose. Analysis of set found F plug defective.No continuity between pin and socket connection, inside F plug . Servicemanual exploded view pg 139, 14-2 showed F plug as pa | ||
| Sony | KV20M10 | VERTICAL JUMPS, REPLACED TUNER | Vertical jumps, found video signal from tuner pin 18 was too low, 1/2 volt. - |