Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | HCDH550M | NO AUDIO, AUD IN OK, BUT NO AUD OUT REPLACE AUD PWER AMP IC | Unit came in powered up but no audio, no fuse or fuse resistor open. | ||
| Sony | HCDH405 | CD MACH JAMS | Aligned unit with HCDH 605 manual on pg 9 of F194-2. Lever 7 locks up on slider assy #1. There are teeth in #1 that #7 rises and slide into. #7 hits the end of the teeth and locks up. I have turned the cam not mov | ||
| Sony | HCDH405 | CD PLAYER JUMPS TIME | Any reports of this unit jumping time and is there any fix? Unit will play 8-10 cd's then jam up. Hand cranking cd mechanism back down to bottom and turning on it will play again for 8-10 cd's then lock up again. | ||
| Sony | HCDH405 | INTERMITTENT CD DRAWER OPERATION RESOLDER SW504 | CDdrawer operates intermittently. Found SW504 on mid sw board soldered at an angle. | ||
| Sony | HCDD560 | DONESN'T READ CD - RESOLDER JW348 | Unit powers up but does not read cd, no focus ok and no laser on. | ||
| Sony | HCDC55 | NO POWER - REPLACE FLAT CABLE REF # 112 | No Power | ||
| Sony | HCDC50 | SHUTS DOWN SHORTLY AFTER POWER ON - TIGHTEN SCREWS ON OUT IC | Unit goes to off/dead when you hit power on. Sometimes intermittent turn on. Mechanism worked ok. | ||
| Sony | HCDC33 | EXENTSION JIG CABLE CSA13 # 412R | Using BXT cables for this unit supplied by 412R, CSA13 is still problem. Need one more flex cable for #70 that goes from CN801 cd sw to CN185 CD board. | ||
| Sony | DTC790 | FILTER CAPACITOR BREAK OFF - REPLACED CAPACITOR | Found C921 and C920 loose in set upon opening top cover.Symptoms could range from no load to no power. It seems as though thecaps were being nicked when inserted and trimmed in the assembly stage.Part of the lead is on the board while the rest is on the | ||
| Sony | DTC690 | FILTER CAPACITORS BREAK OFF - REPLACED CAPACITORS | Found C921 and C920 loose in set upon opening top cover.Symptoms could range from no load to no power. It seems though capswere being nicked when being inserted and trimmed in assembly stage.Part of the lead is on the board while the rest is on the cap. | ||
| Sony | CDPCA9ES | UNIT DEAD - REPL T601 | Unit dead, checked T601 power transformer dead. | ||
| Sony | CDPC525 | INTERMITTENT DIGITAL NOISE IN AUDIO OUT - REPL IC302 | Intermittent digital noise heard in audio. Also static noisein audio before replacing IC301 DSP and IC302 digital filter. | ||
| Sony | XS8031 | PART NUMBER CORRECTION: SPEAKER (CORRECT # IS 1-544-126-11) | The part number shown in the service manual for the speaker isincorrect. | ||
| Sony | XRU800 | NO RESPONSE TO KEYS ON FACEPLATE | The unit would not respond when any of the keys on thefaceplate were pressed (however, the tape control keys would work after atape was loaded). | ||
| Sony | XRU700 | ERRATIC TAPE DECK OPERATION (FOUND ROTARY S902 DEFECTIVE) | Tape loads in steps then ejects. Very erratic movement oftape transport. |