Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
Sony | CCDTR71 | DROPOUTS ON VTR PLAYBACK/REPLACE C289, VS93 BOARD | The unit had not delayed video coming out of 1H delay, IC154,Pin 4. The video input on Pin 1 was good. DC voltages on Pins 12, 13,and 15 were all off. | ||
Sony | CCDTR71 | NO VIDEO ON E TO E / REPLACE IC802, VC112 BOARD | All digital outputs from A/D converter IC802 were at 3.5 volts(even unloaded), instead of between 1V ad 9V. | ||
Sony | CDU7211 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDU541 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDU535 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDU531 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDU520 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDU7205 | WILL THIS DRIVE WORK MOUNTED IN AN UPSIDE DOWN POSITION ? | |||
Sony | CDPC315 | SKIPS AFTER REPLACING SPINDLE MOTOR (ADJUST TABLE HEIGHT) | Skips in normal position but, plays O.K. on side. Adjustmentswould not help. | ||
Sony | CDPC211 | SKIPS AFTER REPLACING SPINDLE MOTOR (ADJUST TABLE HEIGHT) | Skips in normal position but, plays O.K. on side. Adjustmentswould not help. | ||
Sony | CCDTR200 | STICKY IRIS/CLEANED OIL FROM IRIS | No iris movement. Found oil on iris leaves of M904. Itlooked like it may have leaked from the lens assembly or zoom motor. | ||
Sony | KV27TS27 | SYSTEM CONTROL, GROUNDED ALL PINS ON IC101 AND 102 | After wam up, control of functions would not work. Bhin inSan Diego called me and said that replacing the IC102 produced a newproblem. The set would come on in S video with no remote or manualcontrol. He than took out IC102 from a working set, again t | ||
Sony | CCDFX710 | KEEPS BLOWING F-950/CHECK INSULATION AROUND VF CABLE | The unit blows F-950. With the cabinet off the units willplay fine. Replacing cabinet fuse will blow. 7 wire from the view finderto the main board was shorting. Insulated wires and unit appears to workfine.Connector cable is not available through par | ||
Sony | CCDTR6 | PART NUMBER FOR FFC-5 AND CONNECTOR (CB-33) | The part number is needed for the FFC-5 flex cable andconnector that make up CB-33. -HQ COMMENTS: Part number for the connector is 1-636-561-11. Part numberfor the flex cable (FFC-5) is 1-590-113-11. The CCD-TR9 Service MAnual hasmore information on the | ||
Sony | SLV585HF | NO EE OR PLAYBACK VIDEO: RESOLDERED IC004 ON YC112 BOARD. | No EE or playback video |