Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDPC75ES | AUDIO MUTES AFTER UNIT WARMS UP | No audio after unit warms up (disc plays OK & display normal). | ||
| Sony | CDP350 | REPLACEMENT DIODE IS THE WRONG SIZE | The part number 8-719-940-76 155132 crosses in system to partnumber 8-719-107-94 which is a chip component. The original is availableas lead standard diode. -HQ COMMENTS: Thanks for pointing out the error to us. According to the1993 Semiconductor Repla | ||
| Sony | WMD6C | AVAILABILITY OF METER KNOB | Peak/battery switch cover is no longer available. This unit,however, is still in production. -HQ COMMENTS: KCPS had bad sub corrected. Please reorder. | ||
| Sony | ITA305 | SIZE OF RPL SPEAKER | Replacement speaker is too large to fit in the unit. Theoverall diameter is ok. The magnet diameter is twice the size of theoriginal. -HQ COMMENTS: KCP checked with Tokyo for magnet size, which should be5.7cm. Magnet size of KCP inventory are also 5.7 | ||
| Sony | CCDFX410 | AVAILABILTY OF FP-442 FLEX BOARD | We are getting many requests from the field for the partnumber for the FP-442 Flexible board. Is this part available? -HQ COMMENTS: This part is listed in the CCD-FX620 Service Manual page163. Part number is 1-641-639-13. | ||
| Sony | CFD767 | CD DRAWER WILL NOT OPEN | The CD drawer will not open even after the 10 second delay.I found that one or both of the wires (Ref. No. 615 and 616) that connectthe inductors (L-701 and L-702) to the translation board (Ref. No. 651)are not connected. Closer examination showed that | ||
| Sony | CFD757 | CD DRAWER WILL NOT OPEN | The CD drawer will not open even after the 10 second delay.I found that one or both of the wires (Ref. No. 615 and 616) that connectthe inductors (L-701 and L-702) to the translation board (Ref. No. 651)are not connected. Closer examination showed that | ||
| Sony | CFD765 | BOTH DECKS RUNNING AT HIGH SPEED | Both motors were running in high speed. I found a residual1.5V on the base of Q-334 (0V expected). After eliminating all possiblesources found that only by disconnecting the base of Q-312 (mic/mute) the0V is restored on the base of Q-334. Found 6V on a | ||
| Sony | CMH1K | THE UNIT DOES NOT TURN ON | The unit does not turn on. | ||
| Sony | CMH1K | KEYPAD IS NOT WORKING PROPERLY | The right hand side column of keys (which includes END, CLR,3, 6, 9 and #) was not active. | ||
| Sony | TADL100 | NO RMR INPUT | No RMR input control. I have two units with the same problem. | ||
| Sony | SPPA60 | NO MECHANICAL MOTION | Unit did not have any mechanical motion at all. Also pertainsto serial number 32407. | ||
| Sony | SPPA60 | DISTORTED AUDIO | Unit had distorted audio. Traced problem to handset. Alsoapplies to serial number 20376. | ||
| Sony | SPP57 | NO POWER HANDSET | Handset did not have power. Troubleshooting found no reset onIC-501/pin 44. Also pertains to serial number 82634. | ||
| Sony | SPP57 | NO AUDIO ONTO HANDSET SPEAKER | Unit had no sound out of handset speaker. Speaker ohmed at500K Ohm. Also applies to serial number 31698. |