Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | XM3040F | PART NO. FOR FRONT PANEL SWITCH/S-501/502/503/504 INCORRECT | The KCP system cross references the part number for switchS-501 listed in the service manual (1-527-753-11) to a crystal oscillatorhaving a P/N 1-527-753-00. | ||
| Sony | CCDTR6 | INCOMPATIBILITY OF LENS BLOCK ASSEMBLY AND "VC-81" BOARD | Found that connectors CN-803 and CN-302 on the VC-81 boardof a serial number 116964 camera were of the female type. The same conn-ectors of a different camera same model, serial number 26037 were of themale type. These connectors are for the CCD imager | ||
| Sony | CCDF45 | WHITE STREAKS ON VTR PLAYBACK | White streaks on PB, appears to be an equalization problem. | ||
| Sony | KV20TS27 | CLOCK RUNS FAST, ADD CAPACITOR | Clock would gain 10 to 12 minutes per day at customer's homeand at shop. This model uses slightly different singe-transistor circuitin AC REF line than is shown in S/B TVP0087. 60Hz pulse at IC-101/37 wasclean (no noise), 5Vpp, not 50% duty cycle (abou | ||
| Sony | CCDTR4 | EATS TAPES WHEN REWINDING | Unit would eat tapes when rewinding. Found arm assembly gearand supply reel table assembly defective (X-3727-952-1) Reference No. 207is defective. | ||
| Sony | KV32XBR75 | NO PICTURE, DISTORDED SOUND, COLD SOLDER T-500/PIN 2 | Sound was bad and had no picture. Located cold solderconnection on pin 2 of T-500 (Flyback), also found on the F Board, R-603and R-606 open, then found L-601 shorted. | ||
| Sony | KV13TR24 | DEAD, REPLACED IC-601 | Unit was inoperable with no functions. Traced problem to de-fective IC-601. | ||
| Sony | ITA4000 | CAN HEAR AUDIO ON SPEAKER WITH VOLUME CONTROL AT MINIMUM | Customer complains that even with the SPEAKER VOLUME controlat minimum, he could still hear the incoming caller through the speaker.This was annoying him, as it prevented him from keeping the incoming callconfidential from the other people in the room. | ||
| Sony | SPP120 | PHONES WERE CUT OFF | The unit was cutting off all the phones in the house and thephone was not dialing. | ||
| Sony | EVS900 | DEAD SET - NO FLUORESCENT DISPLAY | The unit will not power up. The fluorescent display was out.Fuses PS-104 and PS-102 were open. After replacing them, all unswitchedvoltages were normal except the back-up 5V at CN-106 pin 7 on the DT-63board. It read 2.8V. A check revealed that D-114 | ||
| Sony | CCDF401 | VTR SHUTDOWN | Unthreads halfway on eject and rethreads, then shuts down. Noreel sense on pin 46 of micro IC-506 - SS-136 board. | ||
| Sony | STRGX57ES | PCB SILKSCREENED INCORRECTLY/PART INSTALLED BACKWARDS | Servicing dealer in West Virginia reports three units withgoing into protect after a couple of hours after initial turn on. In allthree units he has found the capacitor symbol silkscreened on thepcb to be the reverse polarity of that shown in the manual | ||
| Sony | SPP320 | MOTOR-BOATING IN AUDIO AT BASE | When battery fully charges (charge) LED goes out. Motor-boating is heard on wired handset or on speaker phone. Spikes are seen atnumerous locations in circuit - likely due to current control problem. | ||
| Sony | MDP510 | SERVICE BULLETIN NUMBER VID0106 | This unit and others of this model have already had the modi-fications described in service bulletin No. VID0106 performed (duringmanufacturing). R-161 and C-151 are at the new values and the circuittraces from R-156, R-160 and R-162 to pin 41 of IC-102 | ||
| Sony | CCDV701 | NO AUDIO | No audio from mic. VTR plays and records. |