Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | D180K | NO PLAY | Unit would not play discs. In the test mode no searchfunction occured. There was a reading of 1 volt (B+) on pin No. 38(IC-504). | ||
| Sony | EDV9500 | WHITE DROP OUTS AT TOP OF SCREEN (APPROXIMATELY 2 INCHES) | Unit had white drop outs in top of picture (approximately twoinches in size. | ||
| Sony | STRGX57ES | UNIT GOES INTO PROTECTION WITH HIGH VOLUME ON REAR AMP. | Setting the rear Amp volume to high causes the Protectioncircuit to activate. I connected 8 Ohm dummy loads to the rear output andthe output clips unsymmetrically with a birdie on the positive half-cyclebefore the bottom half-cycle shows any distortion. | ||
| Sony | SLHFR70 | ERATIC OPERATIONS - INTERMITTENT | Intermittently all or incorrect portions of LCD would lightup. Basket would load but not thread with or without tape inserted.Continuous reel motor rotation. After five seconds, basket would unloadreel (motor still running) five seconds later basket wo | ||
| Sony | ITD150 | ERROR DETECTION SIGNAL | Unit randomly gave error signal. At first check unit seemedto be working properly. Upon further investigation, scan pulses werefound on IC-3 pin No. 28, telling the micro to perform a memory function.These pulses were leaking through switch M-2. Acros | ||
| Sony | SPP320 | LOW DIAL TONE AND AUDIO FROM SPEAKERPHONE | Unit had low dial tone and low audio when in speakerphonemode. This was because C-666 was loading down the signal between IC-607pin No. 7 and the Tel-Line duplexer. Also credit Mr. Chipman with thisreport. | ||
| Sony | SPP170 | DISTORTED RING | Install R-610. -HQ COMMENTS: Excellent report. To Tokyo: This is for your information. | ||
| Sony | STRAV570X | VIBRATING NOISE AT HIGH VOLUME | When volume is turned up with speakers off and withoutheadphones connected (unit under no load), the headphone jack vibratesmechanically and produces an audible vibrating noise. | ||
| Sony | TCM4500 | AC ADAPTER MODEL NUMBER/PART NUMBER NOT SHOWN IN MANUAL | The service manual does not list a model number or part numberfor the AC adapter. | ||
| Sony | STRAV1020 | REPLACEMENT PART FOR TUNER BOARD HAS DIFFERENT CONNECTORS | The Tuner Board received from KCP has different connectortypes for CNJ1, CNJ2 and CNJ4. The old type Tuner board has femalepush-in type connectors which connect to the male push-in type connectorson the Main PCB. The new type Tuner board received from | ||
| Sony | CFD460 | INTERMITTENTLY WON'T PLAY DISC | Unit would not play disc. All you would hear is a clickingnoise. If you manually moved sled, it would then play disc. | ||
| Sony | CCDV11 | PART NUMBER FOR CAPSTAN MOTOR CONNECTOR | The service manual does not call out the connector for thecapstan motor as a separate part number and the FP-182 board does nothave the connector attached. -HQ COMMENTS: The part number for this connector is 1-565-662-11 andit is registered in KCP. | ||
| Sony | CCDTR4 | PART NUMBER FOR CAPSTAN MOTOR CONNECTOR/10565-662-11 | The service manual does not call out the connector for thecapstan motor as a separate part number and the FP-182 board does nothave the connector attached. -HQ COMMENTS: The part number for this connector is 1-565-662-11 andit is registered in KCP. | ||
| Sony | CCDTR5 | PART NUMBER FOR CAPSTAN MOTOR CONNECTOR | The service manual does not call out the connector for thecapstan motor as a separate part number and the FP-182 board does nothave the connector attached. -HQ COMMENTS: The part number for this connector is 1-565-662-11 andit is registered in KCP. | ||
| Sony | CCDTR7 | PART NUMBER FOR CAPSTAN MOTOR CONNECTOR | The service manual does not call out the connector for thecapstan motor as a separate part number and the FP-182 board does nothave the connector attached. -HQ COMMENTS: The part number for this connector is 1-565-662-11 andit is registered in KCP. |