Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDPS107 | UNIT SKIPS WITH NEW MD ASSY, DEFECTIVE NEW STOCK | Units needed MD assembly (skips). | ||
| Sony | STRAV270X | NO STATION PRESET MEMORY | After programming stations into preset memory, memory is lostwhen unit is turned off (but still plugged in). IC-301/pin 26 loses the5V when set is switched off. | ||
| Sony | TAAV601 | LEFT/RIGHT OUTPUT DIFFERENCE IN SURROUND MODES | Customer and servicer are questioning normal operation of thisunit. When equal levels are set with surround modes off, then whensurround modes are switched on, left channel has slight gain increasewhile right channel has slight gain decrease. -HQ COMME | ||
| Sony | STRAV570X | RIGHT CHANNEL INTERMITTENT, DUE TO DEFECTIVE VOLUME CONTROL | I have three dealer units with defective volume controls. Twoare with noise and one is distorted. Kansas City has not been able toprovide the control. These are new models. | ||
| Sony | STRAV23 | RIGHT CHANNEL IS INTERMITTENT | I have this unit and two STR-AV570X units with volume controlproblems. Kansas City has been unable to provide the control. These arenew units. | ||
| Sony | CDP291 | UNIT SKIPS, DIRT STICKS TO SPINDLE PLATE ON SPINDLE MOTOR | Disc wobbles when turning and RF waveform is jittering. | ||
| Sony | CCDF501 | NO VIDEO IN RECORD OR PLAYBACK | Video was muted in Record or Playback. -SOLTION: Mask pulse from digital titler IC-901 into IC-201. Pin 29would not end when video was input into IC-201 pin 3. This was becausethe sync det line into IC-901 pin 11 would not stay high. IC-501 (syscon)p | ||
| Sony | KPR46EX20 | INTERMITTENT SHUT DOWN, REPLACED Q-617 | The unit would very intermittently shut off. The initial pro-blem appeared to be a typical high voltage shut down. Closer examinationshowed that it was caused by activation of the OVP line from the switchingpower supply G board. This was caused by a t | ||
| Sony | KV2645RS | INTERMITTENT FOCUS/BRIGHTNESS | After the unit was on for a while, it would intermittentlychange in brightness and de-focus. The problem was caused by intermittentarcing between pin 1/G4-Focus of the CRT and pin 12/G2-Screen. The arcingbetween these two pins was across the glass unde | ||
| Sony | KV27HFR | INTERMITTENT SHUT DOWN, REPLACE IC-681 ON "G" BOARD | The unit would very intermittently shut down. The relay wouldopen in the failure mode indicating a problem with the OVP circuit. Theproblem was caused by an intermittent power module DM-36/IC-681 in theswitching supply. Replacement resolved the proble | ||
| Sony | KV32XBR55 | PULLING/LIFTING FOIL FROM BOARD, Q-502 | Appears somehow Q-502 is pulling away from board. Pulling/lifting foil from board. Foil is still in contact on transistor withsometimes a cold solder joint. Usually emitter pulls down first, thencollector then base. I have seen this problem 6-12 time | ||
| Sony | KV27XBR | Q-502 "A" BOARD PULLING FOIL FROM BOARD HI DRIVE,NO SOLUTION | Appears somehow Q-502 is pulling away from board. Pulling/lifting foil from board. Foil is still in contact on transistor withsometimes a cold solder joint. Usually emitter pulls down first, thencollector then base. I have seen this problem 6-12 time | ||
| Sony | ITA505 | UNIT CUTTING OFF WHEN CUSTOMER PICKS UP OTHER PHONE | Unit cuts off when customer picks up other phone. -HQ COMMENTS: This problem occurs because when an extension phone ispicked up, the tel line voltage drops below 5 volts and the unit cuts off.A tech flash and a service bulletin have been issued to modif | ||
| Sony | CCDF40 | ONLY BLUE COLOR ON CAMERA MODE | When in camera mode, only blue color. | ||
| Sony | CCDV8AFU | CAMERA POWER ON-OFF PROBLEM | Camera switch does not function intermittently comes on whenbattery is put in. It then will not shut off. |