Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV220 | ERROR IN BLOCK DIAGRAM | Block diagram on pp. 42-43 shows DT-62: SH1, 2 and 3 signalsgoing to SP1, 2 and 3 respectively on IC-251. This is incorrect. Theschematic on page 107 is correct. It refers to SH1, 2 and 3 as Gate 3, 1and 2 on CP-21 bd (HIC251). The actual connections | ||
| Sony | CCDV220 | YELLOW PICTURE/NO BLUE IN EE PICTURE | Unit had yellow picture on EE and self-recorded tapes. Noblue was getting through. We checked R-Y and B-Y at W-201. Pin 28 and29, noticing that the B-Y signal was about 5 times greater in amplitudeand did not look like the R-Y. We then checked the SH | ||
| Sony | CCDV220 | VERTICAL (JAIL) BARS IN EE MODE | Unit manifested evenly spaced black vertical bars in EE pic-ture or self-recorded tape. | ||
| Sony | CCDF35 | TAPE IS STUCK INSIDE | Tape is stuck inside unit. | ||
| Sony | MDP510 | DIFFERENCES IN "SV-33" BOARD | This has a different SV-33 board in it. The maindifference, aside from some extra coils in the 5 volt bus is the additionof 0 resistor from pin 1 of IC-102* to C-127 in the focus Yvil circuits.The part number on the board itself is 1-630-095-14. Later | ||
| Sony | CFD460 | MOTOR MOUNT DRILLED WRONG | The motor comes with just two holes drilled in the motor. Theway they are drilled they are 90 degrees off for mount to the board. | ||
| Sony | CCDTR4 | NO PLAYBACK COLOR | Camera had color in the E-E mode but no color in Playback. NoB+ at Q-234, 235 or VS-70 board, buffer transistor. | ||
| Sony | KV32XBR55 | ROM FAILURE, REPLACE IC-102 & IC-301 | No color on main picture but PIP had color. Could not getvideo setting display to come on screen but all other displays were there.When pressing Reset button on remote to get video display, unit would shutoff then come back on. After unit was on for a | ||
| Sony | CCDF77 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-F77. The manual shows it aspart of the drum assembly. It is not included when ordering the drumassembly. -HQ COMMENTS: A service bulletin will be issued on this soon. The partnumber is X-3686-482-5 and is in stock in KC | ||
| Sony | CCDF55 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-F55. The manual shows it aspart of the drum assembly. It is not included when ordering the drumassembly. -HQ COMMENTS: A service bulletin will be issued on this soon. The partnumber is X-3686-482-5 and is in stock in KCP | ||
| Sony | CCDV701 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-V701. The manual shows it aspart of the drum assembly. It is not included when ordering the drumassembly. -HQ COMMENTS: A service bulletin will be issued on this soon. The partnumber is X-3686-482-5 and is in stock in KC | ||
| Sony | CCDV801 | NEED PART NUMBER FOR THE DRUM BASE | I need the drum base for a CCD-V801. The manual shows itas part of the drum assembly. It is not included when ordering the drumassembly.-HQ COMMENTS: A service bulletin will be issued on this soon. The partnumber is X-3686-482-5 and is in stock in KCP. | ||
| Sony | PVM1271Q | NO PICTURE | The unit arrived from the Costa Mesa SSC with no picture. Ablue raster present when the set was turned on. The B board had beenreplaced. -HQ COMMENTS: The sync signal to pin 19 of IC103, B board, was presentbut did not look normal. Traced the problem ba | ||
| Sony | CCDF70 | MAIN CHASSIS FOR "O" MECHANISM | There is no part number in the service manual (page 153) forthe main chassis. On this unit one of the press-fit studs that holds theLS chassis is loose. Is the main chassis available as a replacement part? -HQ COMMENTS: As the O Mechanism is now out o | ||
| Sony | TAN77ES | C313 AND C363 HAVE BEEN CHANGED TO REDUCE P/S RIPPLE | C313 and C363 have been changed to new values in order toreduce the ripple voltage on the constant current power supply line. |