Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonySTRAV1000
SPEAKER PROTECTION ALWAYS ON The speaker protect circuit is always engaged. The problemappears to be related to the power supply. We noted that the schematicshows two separate grounds. In fact there is about 3 volts differencebetween the two. When the two grounds are tied togeth
SonyEVC8
RECORDING COLOR IS BAD Unit was recording with no green component (color bar).
SonyCVM1900
VERY WEAK VERTICAL HOLD Very weak vertical hold and appeared to also have a horizontalsynch problem (another shop replaced IC-501, problem not solved). Spenttime checking DC voltages, waveforms around IC-501, checked ok. Lookedcarefully at waveform on pin 24 of IC-501, vertic
SonyCPD1304
MISTAKE IN S/M "D" BOARD Service manual shows pin 6 of IC-901 On the D Board to beconnected to the 120 volt line. This is not true. There should be noconnection. Fuse in the 120 volt line is missing in the S/M. Has therebeen a correction issued? -HQ COMMENTS: Tokyo will iss
SonyKV27XBR60
"H" BOARD AND IC-51 HAVE BEEN CHANGED, SEE SUPPLEMENT 4
SonyKV32XBR65
H BOARD AND IC-51 CHANGE, COVERED IN SUPPLEMENT NO. 4 H Board and IC-51 have been changed. -HQ COMMENTS: There has been a change in the H Board and with IC-51.Service Manual Supplement number 4 has been issued to cover these changes.H1 Board 1-629-621-23IC-51 8-741-100-62 CBX-1618-51
SonyKV32HSR10
VERTICAL LINES IN PICTURE, SERVICE MODE ADJ "REF" SET TO 1 Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV32XBR65
VERTICAL LINES IN PICTURE, REF MIS ADJ, ALSO CHECK R-517 Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV27XBR15
NEW H BOARD, REFER TO SUPPLEMENT NUMBER 4 H board and IC-51 have been changed. -HQ COMMENTS: There has been a change to both the H Board, and IC-51.Service Manual Supplement number 4 has been issued to cover thesechanges.H-1 Board 1-629-621-23CBX-1618-51 8-741-100-62 IC-51
SonyKV32XBR15
RGB VERTICAL LINES IN PIX, ADJ. "REF" IN THE SERVICE MODE Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV32XBR10
VERTICAL LINES IN PICTURE, ADJUST "REF" Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV32XBR15
H BOARD AND IC-51 HAVE BEEN CHANGED, REFER SUPPLEMENT # 4 H Board and IC-51 has been change. -HQ COMMENTS: H Board has been changed to the H1 Board (1-629-621-23).There has also been a change in the sensor IC, it has been changed to P/N8-741-100-62 (CBX1618-51). Please refer to Service Manual Supplement - 4Fo
SonyKV27HSR10
HORIZONTAL RGB, LINES IN PICTURE, CHECK R-517 Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV27XBR65
RGB VERTICAL LINES TOP OF PICTURE, SEE TVP SB # 76 Three to four retrace lines are visible at the top of thescreen. They do not look like ordinary retrace lines, but are of solidred, blue, or green colors.
SonyKV32XBR50
FAINT HORIZONTAL LINE, TRACED TO LIGHT DIMMER SWITCH While viewing some channels, you could see a very fainthorizontal line quite narrow moving up very slowly from the bottom of thescreen to the top. This problem has been seen many times in the past andis related to 60Hz interference.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads