Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18938
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV27S20 AA-2 | CLOSED CAPTION | KV27S20 serial # 7042141 Unit will not operate in the closed caption mode if using the DVD player. However if the television operates in the tuner mode for over the air telecasts, closed caption works fine. | Tech needs to order IC001= T-935-001-61 per bulletin R329R1. After replacement the tech will need to enter the tech menu and select ""CRIW"" and change it from 15 to 3. Also check the ""LBLK"" must be 7, ""RBLK"" must be 7 and ""HBSWO"" must be 0. At this point save the new data and "" | Muller |
| Sony | KV35XBR48 AA-2 | CHROMA | Unit is connected in to component video input mode through a DVD player. The picture has a predominately green picture | When operating a different DVD player the symptom is the same. There is no cure to this phenomin from Sony at this time | Muller |
| Sony | KV35XBR20 0 AA-2 | CHROMA | KV36XBR200 When the customer is using the RF input labeled VHF/UHF the set will picture will lose chroma intermittently. But when using the AUX input the chroma is solid and does not vary. The tech replaced the RF switch without effecting the symptom. | The customer is using two different RF sources. Cable TV and a satellite dish. The CATV is being feed into the RF input labeled VHF/UHF and the satellite is fed into the AUX input. It appears the tuner does not correct the AFT when two different RF sources are used. The channel will has to be readdressed again for any AFT correction to occur. Suggest the customer used the satellite in the S-video and separate video input mode. In his present configuration the customer is loosing all stereo reception, and all high frequency detail over. This corrected the symptom. | Muller |
| Sony | KV35S26 AA-2 | chroma | KV35S36. Unit has random chroma phase shifting. The tint will vary radically. NTSC color bars are not stable. ""Barber Polling"" effect of colors on bars. "" | Suggest the tech look very close to the connection s to IC351(4) This the Chroma AFDC filter. Components R354, C355, C355 are in the AFCFIL circuit. It is possible the trouble is a Jungle IC but Before replacing it is recommended to check the aforementioned components first. Note: when checking the components it was found that C366 has glue touching each end of the device. The glue effectively changed the value of the device. Cleaning the glue and reinstalling the device corrected the problem. | Muller |
| Sony | KV35S26 AA-2 | CHROMA | KV35S26 Unit has the tint phase shift and color lock up problems only on the Hughs satellite receiver. VCR and over air signals have solid color lock up. | This symptom acts like it is a problem with the satellite receiver. Inside the satellite receiver there is a NTSC encoder which injects the 3.579547 MHz color oscillator signal in the video. If this oscillator is too far off frequency it will not phase lock with the 3.579545 MHz in the television. This is a software problem with the Satalite receiver. A software download will be available to all receivers in Late | Muller |
| Sony | KV27S22 AA-2 | BRIGHT RASTER | KV27S22 serial # 8102548. Unit goes to a bright blue screen with retrace lines then shuts down. | Unit has a defective CRT. When unit is able to turn back on again the set will sometimes be in the video input mode. | Muller |
| Sony | KV35XBR35 AA-2 | B&W Tracking | KV35XBR35. Unit has color temperature error in the YUV input mode only | According to Sony tech support there is no adjustment for this input. Refer this customer to Sony customer affairs. | Muller |
| Sony | KV27V65 AA-2 | audio | Sony KV27V65 Sound does not ramp up correctly. Seems to get very loud as soon as the volume gets higher in a very short time | I had tech get into the ID codes and reset ID2 from 239 to 175 and ID 4 from 130 to 194. Then initialize the EPROM . Set returned to normal operation | Muller |
| Sony | KV27S36 AA-2 | audio | Sony KV27S36. Unit has choppy SAP audio. Stereo 0.K. | All SAP, Stereo, and mono functions come from the Tuner assembly and nowhere else. If a problem exists for the S.A.P. feature all circuitry relating to the feature is replaced when the tuner assembly is replaced. Recommend the Tuner/IF/MTS decoder assembly. Replacement corrected the | Muller |
| Sony | KV27S20 AA-2 | Audio | Sony KV27S20. Unit has a low pitch whine in the left audio channel. | Problem is best heard in the video input mode with no signal put to the input. It can be seen with an oscilloscope on one of the output pins of IC1401 but not on the input. Part number is 8-759-369-39. IC1401 corrected the trouble. | Muller |
| Sony | KV32S65 AA-2 | audio | KV32S65. Serial # 8014575. Sound and picture is fine but when the fixed or variable audio out is connected to an external audio amp and the set is muted a loud pop is heard in the right channel. | I had the tech try to measure if there was any DC voltages that resided on the Variable audio output connectors. There was ""4.5"" volts on the Right channel and ""0"" volts on the left channel. When the ""Mute"" transistors on the variable line triggered they pulled both lines to ground. When the external amp was connected to this circuit the input capacitor for the right channel charged with this 4.5 volts. We still had audio on this line even though it was at a 4.5 vdc potential. But when the Sony muted, the input capacitor inside the Big External amp discharged and caused a tremendous pop. C172 is a .47mfd used to decoupling the audio from IC101 the Variable audio control IC. This capacitor had 4.5 vdc on each leg measured to ground. Removing the capacitor and measuring the DC resistance across the cap measured 175 ohms. Replacement of the capacitor corrected the symptom. "" | Muller |
| Sony | KV27S45 AA-2 | AUDIO | KV27S45 serial 8046950 Unit has a very rapid change in volume when increasing the level from minimum to 4 notches above minimum | Tech needs to add a resistor in parallel with R432 to effectively reduce the value of R432. This changes the voltage divider ratio to the volume control circuit and makes the volume circuit more linear in operation. | Muller |
| Sony | KV27V65 AA-2 | AUDIO | Audio level adjustments will not increase in a linear fashion, instead the audio will increase rapidly in the first 1/3 of the bar graph. | A new microprocessor is available for this unit. It is part number T-998-600-32. It replaces the original IC001 which was M37273MF-251 | Muller |
| Sony | KV35XBR48 AA-2 | ARCING | KV35XBR48 serial 9014229. TUBE ARCING IN THE NECK | unit will need CRT A89LJT80XZ | Muller |
| Sony | KV35V76 AA-2 | ARCING | KV35V75 CRT is arcing in the neck | The CRT is bad. | Muller |