Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCDP302
SOLDER CONNECTIONS Bad solder connections on the IC201 and IC308 chips. Somepins were never soldered. Different pins at different times. That wasthe only problem. -HQ COMMENTS: No FPRs, but I have heard about some bad solders on IC307.Will report to Tokyo.
SonyKV1961
MISSING P/N FOR VHF CHANNEL NUMBERS, X-4365-202-1 Missing part number for VHF channel numbers. -HQ COMMENTS: The VHF channel numbers come with Holder Ass Label'(P/N X-4365-202-0).
SonySLHF300
TAPE DAMAGE This unit had distorted audio and lower edge of tape waswrinkled. Pinch roller rubber was machined wrong.
SonyEVS700U
CLOGGED HEAD This unit had a snowy picture.
SonyXR85
NO EJECT CASSETTE H.G. Brix Co. reported these units would not eject tape. Hereports many problems with this.
SonyCFS9000
HEAD WOULD NOT ENGAGE Head bracket assy (X-3319-204-1) was broken on the headrotator.
SonyCCDV8
NOISE BAND IN PLAYBACK MODE Noise band at bottom of picture. Grease was found on pinchroller and #4 and #5 guides.
SonyKV1770R
NO SYNC No sync.
SonySLHF600
WRONG PART # FOR HEAD Upon looking up P/N for the head disk assembly on Page 130 inthe S/M Ref. #255, it lists P/N as being A-6762-177-A. This is incorrectsince it is only a 2 head disc according to the fische. It showsA-6762-178-A as being the correct P/N for this model.
SonyCCDV8
NO FUNCTIONS This unit would power up but not engage any functions. Wefound the M switch to be jammed. Replacement resolved the problem. -HQ COMMENTS: So far we have not seen many reports of defective modeswitches.
SonySLHFR60
BEAT LINES WITH CABLE In E-E mode, unit would operate normally on an off airsignal. When operated on cable TV there were several beat lines inpicture.
SonyXR65
INTERMITTENT SQUEAL ON FM Intermittent squeal, FM only.
SonySTRVX300
BOARD LAYOUT INCORRECT IN THE MANUAL Functions won't switch. Servicer trying to check IC502 andsays that the hook-up is different from the manual and that the board issilk-screened differently. He says Pin 6 goes to ground and Pin 8 isgoing to B+ on his board. -HQ COMMENTS: The board ove
SonyKPR4150
NO TURN ON When power is turned on, only sleep light would come on.Found F3 (2.5A) fuse blown. At full voltage, the +18 volt line draws2.4A. At normal voltage, the +18 volt line draws 1.5A-2A. At lowvoltage, the +18 volt line draws 1.0A. After fuse replacement
SonyKV1952RX
RETRACE LINES AND SLIGHT FOLD-OVER AT TOP OF RASTER Retrace lines and slight fold-over at the top of the raster.Dealer called me regarding this problem, also intermittent.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads