Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CFS350 | NO AUDIO OUTPUT | No audio output. | ||
| Sony | SLHF300 | PINCH ROLLER SOLENOID REPLACEMENT | Replacement part (identical number) has stop washer onplunger. Washer is too large to allow proper installation of motor andgear assembly. | ||
| Sony | SL2400 | NEGATIVE PICTURE DURING C/R | During CUE, REV or PAUSE the unit would intermittently producea negative like picture, we found delay line DL-1 to be open. | ||
| Sony | KV2680R | NO PIX, NO SOUND, LEAKY C-104 REPLACED | Unit when turned on would come up with high voltage but nosound, no picture and no control from front panel of any function. FoundC104 reading 150 Ohms on Pin 15 of IC105. This capacitor caused no Mclock on Pin 25 of IC103. | ||
| Sony | CFS5000 | WRONG P/N | No such part number (A-3247-124-A) and CFS-5000 has 2 colors. Holder, Cassette (Gray) X-3321-505-1 Holder, Cassette (Gold) X-3321-505-2 -HQ COMMENTS: We will issue a S/B. | ||
| Sony | D5 | NO POWER | Unit had no power. | ||
| Sony | CCDV8 | NO E TO E | No blanking. | ||
| Sony | CCDV8 | NO EJECT | No mode power DC. | ||
| Sony | CCDV8 | BETA SCAN NOISE | Beta scan damaged tape. | ||
| Sony | TV520 | DIFFERENT PINOUT | Substitute picture tube has different pinout than originalone. KC says that this is a good sub but a bulletin was issued on howto rewire set, I can find no record of it. -HQ COMMENTS: We will investigate this problem and if necessary, issuea T/N and S/ | ||
| Sony | SPP11 | NOISE IN HANDSET | Hand set would make all kind of noises. When power was firstturned on, it would dial one digit. | ||
| Sony | SL10 | NOISY SPECIAL EFFECTS IN BETA II | Beta II Pause, Betascan and Beta Skipscan is noisy anddifficult to watch. -HQ COMMENTS: This is normal operation for the SL-10 in Beta II opera-tion. This model does not have the required 1/2H delay line or the jogprocess IC which is used for error fre | ||
| Sony | CFS5000 | INCORRECT P/N - BAND SELECT SWITCH | Part number ordered is also stamped on part received. Partordered is two position switch approx. 1 1/2 inches long with 8 pins inmiddle, part received is approx. 2 inches long with 16 pins along entirelength. We think part number in the manual is wrong | ||
| Sony | CCDV8 | DRUM WAS NOT STARTING | Drum was not starting. | ||
| Sony | CDP200 | CHUCKING ARM ASS'Y | Chucking arm seems to be the biggest problem on this model.Can the arm assembly be updated to the magnet type used in CDP-302? FSCshave chronic complaints and no positive solution. -HQ COMMENTS: The CDP-200 has no magnetic type arm assy. To correct th |