Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV1923 | PICTURE NOISE | Retrace line. | ||
| Sony | KV1923 | DEAD | Dead set. Found defective the following parts F602, Q901,D514, D502. After replacing defective parts it was found R560 and R561were getting hot. Traced cause to an open contact between circuit boardand L502 the HLC coil. | ||
| Sony | KV1914 | NO UHF | No UHF. Found B-E of Q103 shorted. | ||
| Sony | KV1913 | SOUND ONLY ON CHANNEL 5 | Intermittent or garbled sound only on channel 5. Because theproblem was only on channel 5 the audio IC and outputs were ruled out.Monitoring Q107 it was found to be muting on and off when on channel 5.NL2204 was then replaced and the problem was cured. | ||
| Sony | KV1912 | CHANNEL NO CHANGE | Cannot change channels, push buttons will not light whenselected. Found 35V missing at Pin 10 of IC033. | ||
| Sony | KV1746R | DEAD, REPLACED HDT | No raster - no high voltage. Servicer confused with hi-voltshut down. Virtually lost scope pattern at secondary of horizontaldrive transformer. | ||
| Sony | KV1722 | PART RELIABILITY | SG-613 supplied was installed by service station. Partfailed immediately. Cones on part are not correct for use in Sonytelevision. Construction of part is different in appearance to partssupplied by Kansas City. Code on part: OK-H. -HQ COMMENTS: In | ||
| Sony | KV1545RS | VOLUME RANGE TOO LIMITTED, CHANGE R102 TO 100K | Sound is either too low or too high. Customer states thathe thinks the volume should move from low to high in a slower manner,rather than jump from low to high. -HQ COMMENTS: We can satisfy the customer by changing R102 resistorvalue from 10k to 100k. | ||
| Sony | KV1515 | NO SOUND | Failure of sound section of IC201 due to static discharge inlow humidity environments. Have scrapped volume slider decorative buttonto remove excess silver plating. No help. -HQ COMMENTS: We are sending you a countermeasure proposal involvingapplicati | ||
| Sony | KV1512 | PICTURE DISTORTION | Slight fold-over in center of screen. C406 apparently driedout over the years. Located off emitter of ABL Q4091. | ||
| Sony | VTX1000R | NO POWER ON | No power-on switching using front panel switch (S802) orremote. Customer claimed power would come on intermittently and thatother functions such as video switching, antenna switching would workerratically (this was not verified). When S802 is depressed | ||
| Sony | KX2501 | NO SYNC, REPLACED Q317 AND Q318 BOTH SHOULD BE 2SA1175 | Unit had no vertical nor horizontal sync. According toservice manual, Q317 sync SEP-1 should be 2SC2785 and Q318 sync SEP-2,should be 2SA1175. | ||
| Sony | KV9000 | VERTICAL DISTORTION WITHOUT VIDEO | Vertical collapse under no signal condition. Set appeared tohave proper vertical waveforms when receiving off the air broadcast, butwhen no station present only a thin line, this indicated oscillatorfailure or no self-sustaining ability. | ||
| Sony | KV5000 | NO OPERATION WITH AC | Set would not work on AC. All DC checks which we could thinkwere performed. Power supply simply would not start. Found waveform 27would appear for just an instant and die away. Transformer T606 checkedgood so C611 must be culprit. | ||
| Sony | KV3000R | DOOR JAMMING | Left side door was found to be inoperative when inspected bydealer. Found mounting bolts loose on motor assembly. Motor ass'ydrive gear could not engage in door drive track. Bold heads had pulledinto soft wood due to shipping and handling jolt. |