Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
SONY | KV-25FV10B/KV-29-34-38FV15B | Imagem sem cor (tela principal e tela pip) | No primeiro modelo trocar o C320 sem medir. Nos outros trocar o C309. Na placa pip trocar C3366. | ||
SONY | KV-29FS100/FV300/34FS100/FV250/38FV250 | Tv sem imagem, som normal, ou não liga e fica em stand-by | Trocar o IC702 da placa do trc, verifique o R553. Veja o indutor L701, se for de 100micro beleza, se for de 68micro, troque por de 100. | ||
SONY | KV-29FS100 | Queima o Q512 do “pin” direto e vi que o defeito foi provocado. Fly bom, ci do “pin” bom, fonte bom. O pior que o led pisca 3 vezes | Foi propositalmente trocado as posições dos capacitores C514 e C554. O C554 no lugar do C514, ou seja, no lugar do 680n/250v foi colocado o de 2n7/1600v e vice-versa. Fiquemos em alerta com tv que vem de outra oficina. No caso acionava a proteção de sobre corrente. | ||
SONY | KV 2158B | Imagem com o colorido cheio de interferências, em alguns canais fica sem cor. Isso também acontece no AV descartando assim problemas no varicap ou RF ou CAG. O defeito parece ser de sintonia mas no AV também dá. | Filtro cerâmica YCM351 que separa o vídeo do crôma com defeito. | ||
SONY | LINHA KV | Na tela bem no rosto dos personagens, notei umas finas listras tipo venezianas bem separadas uma das outras, como se foçe pequenas ondas na tela e só nos canais altos, nos canais baixos, UHF e AV normal | trocar o ci CXA JUNGLE DO RGB. Também costuma dar o defeito de riscas azuis no topo da tela, troque o ci. | ||
Sony | KV32S10 | Relay clicks continuously at switch on | Replace Flyback | ||
Sony | KVM2511 AE1 | Can not switch on the set, supply ok | Suspect L807 of o/c Pt no. 140750400 also check R008 and C017 | ||
Sony | KV27EXR25 | No raster, the set will click on but no high voltage | Replaced IC651 on the power board type STRS6301 Note: Use an original STRS6301, not an STRS6301A unless the 6301A comes from SONY This part does run very hot | ||
Sony | KVA2542 | Fault not limited to this model. Turning itself to standby, mostly when warm. Flashing error code on LED's. | Dry joint on IC TDA8179 under metal shield. May need replacing with STV9379. May also need to alter picture geometry settings HSIZE, HPOS, VSIZE, VPOS in service menu | ||
Sony | FE-1 | Set shuts down shortly after start up with standby led flashing 2, 4 or 5 times | Check / replace chip resistors R543 47Kohms and R541, R573 and R575 all 100Kohms | ||
Sony | FE-1 | Changes channel or volume adjusts by itself | Check S900/1/2 on pcb H1, alternatively this could be due to failure of IC005 CD4052BCM-FL63 on pcb A | ||
Sony | FE-1 | No power no standby power supply op | IC609 TOP209 was faulty, also checked C640 47uF, 25v, D631 MTZJ-12B, D628 P6KE200, D629 UF4005PKG23 and R627 4.7ohms, 5%, 0.25w as a precaution | ||
Sony | KV20TR22 | Intermittent reception on VHF / UHF | Resolder tuner especially the around the tuner I.C | ||
Sony | BE3D | Picture too big, maybe strange colors, shuts down after a few seconds | Check for shorts in IC606 9V voltage reg | ||
Sony | BE1 | Loss of sound when set was cold / extremely distorted sound when cold after set was turned on | Sound recovered within a few minutes of turn-on and was then normal. Check the electrolytic capacitors and diode near to the audio output IC heatsink. 100% rectification was achieved by replacing the diode and small value electrolytics in the immediate area of this IC's heatsink |