Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV2184-34
Won't start, pin 41 (stby) of microcontroller is high.Replace Q003. No leak or any other defect was detected with a VOM.
SonyKV2184
Switches off on bright scenesR621 1R in psu slightly hi (1R4)
SonyKV2184
Dead - STR50115 overheatingReplaced chip (s/c pins 2 & 3) but still dead; D608 R2M diode s/c & PS801 800mA cct prot o/c
SonyKV2184
Chans won't lock when tuning & garbled OSDLA78LR05 5 legged 5v reg with µ reset built in faulty
SonyKV2170
Dead - PS603 o/cReplace the 1.0A IC Link [ICP-N25] PS603 (1-532-637-11) by the 2.5A IC Link [ICP-N75] (1-532-686-21). Add the MTZJ-T-77-5.6B Diode D613 (8-719-923-38) between pins 1 (cathode) and 9 of IC603. Add the MTZJ-T-77-5.6B Diode D614 (8-719-923-38) between pin 9 (cathode) of IC603 & ground.
SonyKV2153M
Dead with LOPTr s/c & sec prot diodeAlso replaced opto, res & caps in psu - after which inability to tune manually. Use the auto tune facility
SonyKV211XMTU
Int goes bright greenQ311 buffer display tr on video panel - 2SC2785 used as official replacement
SonyKV2096/92
Int swaps between Tuner/AVFracture in earths on sigs board by screen can clips
SonyKV2096
Text shows blank screen onlyRV3 Txt preset contrast pot 100R o/c
SonyKV2075
POOR CONVERGENCEL551
SonyKV2060/62 Mk1&2
blank raster and no sound although it appeared to lock sync blank stable pic )1/ D 102 in the mute cct ( MK1 versions only ) 2/ D 306 in pulse shaping cct ( Both Versions )
SonyKV2032ME
Pic only 3" wide on lh screen- increases as it warms upC514 = 33uF / 160V ; C801 = 22uF / 250V ; C557 = 2,2uF / 160V .
SonyKV2032ME
No horizontal synchronisation when cold.Replace capacitor C509 10uF near horizontal driver transformer.
SonyKV2032
Won't start, dead.Check/replace R627 2,2M resistor in the power supply.
SonyKV2022UB
Right hand side of picture blank for 5 mins.C621 ( 33u f , 160v ) on power supply.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads