Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV14LT1U
Reverts to st/by aft few minsR618 270k hi res
SonyKV14FV1
goes off after 30 secresolder links JW1, JW2, JW3
SonyKV14F1, KV21F1
No pic - raster visible when A1s turned upIC902 L78L33 3.3V reg feeds Txt I/C on the bottom VCR board
SonyKV1462
Negative picDry joints IF201 module
SonyKV1422
Won't power upQ503 leaky - tested ok out of cct also C801 22µ 250v s/c
SonyKV1420
Raster - bright blue.Ty slight adj of G2 first anode supply.
SonyKV1412UB
Striations on lh sideC534 22µ 250v
SonyKV1400UB
Sound absentR254 390R in 105v supply o/c
SonyKV1400
Tuning drift - intermittent.DJ in BT871 tuner on ground & print.
SonyKV1400
Dead - F601 3.15A o/cR601 3R9 10w o/c; Q605 Chopper s/c; R627 0R47 1w o/c; C518 330pf 1kv leaky & was the cause
SonyKV1340
Hum bar & lack of width.C523 ( 10u f ) o/c.
SonyKPS112U -proj
Int convergenceD/Js on one of the STKs on convergence panel gain access to the convergence panel by taking off the panel below the screen at the front.
SonyKPRS46MH1
DeadMains fuse 6.2 A, Q603 & Q614 2SC4582, R604 0R1, D604, D10 SC6M (+18v) & both STK4728 and 1R res
SonyKD28DX40U KD32DX40U
tuning options in the menu are greyed out.After initial installation, analogue & digital chans can be tuned together by pressing & holding auto-tune button on set's control panel (bottom right). After choosing not to adjust the picture rotation, press OK to commence auto-tuning. If only analogue or digital systems need to be tuned - select appropriate mode (analogue or digital). Analogue chans can be tuned in normal way through menu (not greyed out in analogue mode). Digital chans can be tuned by pressing i+ on the remote, then selecting blue SET-UP option, & finally selecting AUTO TUNING from menu.
SonyHF
REPEAT FAILURE OF Q651CHANGE DAMPING DIODE D654 ON FA BOARD FIT RGP02-17 Pt No. 8-719-976-64


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads