Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | FE2 | Reverts to st/by at sw on with 2 or 5 flashes from LED | 5 flashes indicates an AKB error (Grey Scale Correction). This is normally due to LOP shut down & there is no EHT or sec line volts. Normally due to faulty R618 (270K ohm). This res is in the current sensing cct & could therefore potentially give you an over-current error (2 flashes). | ||
| Sony | FE2 | Line tearing, ragged verticals, arcing noise. | incorrectly fitted EHT lead at the LOPT end. Follow bulletin reference TV05900 for correct fitting. | ||
| Sony | FE1A KV25FX20D | St/by only - flashes twice (prot mode) | IC606 STRF6654 low res of 140R between pins 4 & 5 (should be 3M) | ||
| Sony | FE-1 KV29X5U | no remote, front buttons are Ok | D908 9.1V zener leaky on H board | ||
| Sony | FE1 KV29X5U | Vol OSD perm displayed & front controls give wrong functs | Leaky front control switches - can be cleaned with luck/care | ||
| Sony | FE1 KV29X5L | Stuck in standby with two blinks from front LED every few seconds. | Replace L.O.P transistor 2SD2539. S/C due to poor soldering of scan caps on collector. | ||
| Sony | FE-1 KV29K5U | pink band on LHS, only obvious on dark bachground | video lead from CN504 on A PCB to CN704 on CRT wrapped around L537 (LINE LIN), tie bottom edge of loom to the hole provided in top right corner of S PCB | ||
| Sony | FE-1 KV29K5U | no remote operation | D907 BZX79C9V1 leaky on SIRCS line | ||
| Sony | FE-1 KV29K5U | dead, in stby | C515 220uF 25V s/c | ||
| Sony | FE1 KV25X5U etc | Enters search mode as soon as its switched on | replace SS902 preset search switch and clean PCB that it is mounted in | ||
| Sony | FE-1 KV25X5U | yellow line down screen about 2 inches from RHS | IC301 CXA2060BS (875208838) | ||
| Sony | FE-1 KV25X5U | comes on then goes off, red LED is on | stby IC609 TOP209P u/c | ||
| Sony | FE1 KV25KSU | FRAME IC HOT LINES ON SCREEN | REPLACE C506 0.01MFD | ||
| Sony | FE-1 KV25K5U | not starting up, LED flashes 4 times | T511 breaking down at switch on, replace T511 (145326411 for 25", 145326511 for 29") | ||
| Sony | FE-1 KV25K5U | lines across screen, frame IC running hot | C506 0.01 uF |