Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyAE2
Sound cuts out when vol turned upD/J on X1101 crystal on Nicam PCB
SonyAE2
Shuts down aft 30 secs then sw back on aft few mins then repeats sequence - no leds litHT measured 61v (st/by mode) - st/by 5v to micro low at 0.7v. Cct prot PS681 int high res (On board A near front adj to board D)
SonyAE2
Set will only display one station if another is seEAROM ( ST24C16 ) Data corrupted replace & set up
SonyAE2
Set comes on then collapses into lines in the centCheck H.T. for 119V if low at 70V Q613 IN AUDIO PROTECTION CCT Pt No 8-729-216-22
SonyAE2
RANDOM SPIKES AND DIST. HIGH SOUND LEFT SPEAKERADD 3K3 RES AND 0.015mfd CAP PARALLEL TOC201
SonyAE2
Pic int blanks out then shuts down & restartsLoss of field o/p - dry joints fop chip (next to lopt by back panel)
SonyAE2
Pic goes narrow with lines & high pitched whine LOPTxHT low at 70v - Q613 2SA1162G in audio prot cct faulty - critical pt no 8-729-216-22
SonyAE2
PERIODICAL SWITCHING OFF AND ON ( 10 secs )REPLACE IC003 WITH AE20 TYPE VERSION V2.82
SonyAE2
ODD LINEARITY FAULTS LOOKS LIKE RINGINGCXD2018Q IC561 48 PIN SURFACE MOUNT DEVICE ( GOOD LUCK!! ) Pt-No 8-752-347-92
SonyAE2
No sound/pic - 1 led only litdry joints fop chip - also check other areas for drys
SonyAE2
NO COLOUR WITH VTR PLAYBACK ESP. 2nd GEN COPIES ,TO TDA9145N3C Pt. No. 8-759-343-40 , REPLACE L307 ( 4.7uH ) BY LINK WIRE REPLACE R316 ( 33k ) BY A 100k Pt No 1-216-097-00
SonyAE2
No colReplaced TDA9145 dec chip IC301; TDA4660 chroma del line; Xtals X301/2
SonyAE2
LED display indicates set in protection modeDisconnect protection line from micro if set comes on with small field EEPROM u/s
SonyAE2
Int pic blanking leaving OSD & dark green rasterAdj auto green cut off & adj grey scale using electronic screwdriver settings
SonyAE2
Int goes to st/byDry joints R854 depriving field o/p supply & causing prot shutdown


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads