Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | ITA555 | NO PLAYBACK AUDIO | Intermittent mech problem on this unit. Replace new mechass'y, still no audio on playback. Ans machine works ok. You can seehow many messages were recorded but no playback off message. | ||
Sony | MDP650 | WON'T INIIALIZE- TILT WAS JAMMED | Unit won't initialize. FOP would jump a few times and then the unit would shut down. | ||
Sony | TAE2000ESD | INTERMITTANT NOISE IN FRONT CHANNELS - RESOLDERED DIGITAL BD | Intermittant crackling noise heard in front speakers. | ||
Sony | STRGX800ES | LOW BUZZING NOISE - GROUND IC744, 745, 746 FLOATING PINS | In all modes, with volume control at minimum, there is alow buzzing noise in both channels. | ||
Sony | STRD1015 | UNIT DEAD - REPLACED OPENED DIODE, D202 | Unit dead but power relay would close then open when powerwas applied. | ||
Sony | STRD1015 | CENTER CHANNEL DISTORTION - ADDED GROUND WIRE | When using test tone in Dolby surround mode distortion isheard in the center channel as the rear channel test tone is active.Sound appears to be bleeding through rear channel to center channel.Center channel distortion is also noticable if rear channel v | ||
Sony | STRAV770X | UNIT WILL NOT TURN OFF/NO REMOTE RESPONSE - REPL D202 | Unit remained on after pressing power switch. Also, remotewould not turn off unit. | ||
Sony | SDP777ES | REAR CHANNEL CUTS IN AND OUT - REPLACED IC102 | Rear channel cuts in and out. | ||
Sony | MDS302 | NO RECORD AFTER REPLACING OVERHEAD LIGHT - REFORM HEAD TABS | After replacing the overhead light record head the unit wouldnot record. | ||
Sony | HCDD560 | HIGH TOP LASER CURRENT ON KSS 213 B/1 | Skipping and related cd problems. Observing RF signal and Inoticed distortion on bottom half of wave. Amplitude was almost 2 volts. Turned down laser curreent on optical until it was 1vpp. RF is now very clear and | ||
Sony | CDPC365 | BU ASSY DOES NOT MATCH SERVICE MANUAL | BU-5BD20 is used in Malaysian production models only. | ||
Sony | XRC610 | INTERMITTENT UNIT, POWERS UP THEN GOES DEAD | Unit goes on for a while, then it goes dead. Found R783on the ACC line open. | ||
Sony | XR340 | LOCK PLATE SCREWS LOOSEN UP | The Lock Plate (REF#13) and screws (#10) will vibrate outof top cover (REF#1) see diagram from page 52 of the service manual. Thelock plate will then fall onto main board causing much electrical grief. | ||
Sony | GEN-CAR | CABLE HARNESS PART NUMBERS FOR DHGX4 CAR STEREO JIG | A list of cable harness part numbers for the DHGX-4 CarStereo Test Jig are available. Refer to Car Stereo S/B (CSA-14) No. 368for details. | ||
Sony | GEN-CAR | DHGX4 CAR STEREO TEST JIG MOLEX CONNECTORS & PINS AVAILABLE | The Molex connector plugs and sockets along with the pins areavailable from WRPC-AS. These parts can be used when creating new harnessconnections for the DHGX-4 umbilical cord. |