Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
ITT | CVC1100 | Dead - fuse Si651 Blown. | D658 ( ZPY120 ) s/c. ( over-voltage protection ) | ||
ITT | CVC1100 | dead | 1A fuse o/c; BU536 s/c; D658 120v zener s/c; T713 BC328-25 leaky b-e | ||
ITT | CVC1100 | Brightness low / over scanned after new LOPTX | The LOPTX just fitted is faulty! | ||
ITT | CVC1100 | Blank raster & flyback lines int. | Crack in print from 12v reg on stand up side panel. | ||
ITT | CVC100 | dead with whistling only from psu | No 115v HT - 120v zener D658 leaky | ||
ITT | CTV1204 CVC1204 | Dead. | Blows BU508 at switch on , check C701 for s/c. | ||
ITT | CT600 CVC823 | Line pulling - two or three times a second. | VCR switch on PB unit. | ||
ITT | CT600 80R | Line pulling or jitter intermittent. | Pk on video button - check VCR switch for grease on pins | ||
ITT | CT3835 Comp 80 | Going into standby after a few minutes. | C703 ( 10u f , 50v ) little blue one. | ||
ITT | CT3835 | NO PICTURE RASTER OK | T401 BC548 OC ( NO SANDCASTLE PULSES ) | ||
ITT | CT3725/1 80R | Stuck in standby - with a noise from LTB. | D732 ( BY500-400 ) s/c can use a RGP30 | ||
ITT | CT3537 | Int dead | IC405 5v reg | ||
ITT | CT3437 Comp B | No startup just a low single thud. | LOPTX D050/37 TFAT 3806 | ||
ITT | CT3436 Trimline | Brightness at maximum. | T1412 ( BC546 ) | ||
ITT | CT3435 | St/by only | LOPTx - LOT192 Grandata u/s |