Dicas Reparação PANASONIC
Modelo - Chassis
Pesquisa: PANASONIC Enviar Dica Resolvida
Resultados 2641
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Panasonic | Z5 | No col | eeprom IC1205 faulty - no set up data for IC601 | ||
| Panasonic | Z5 | Int thick lines across screen | Dry joints tuner | ||
| Panasonic | Z5 | Dead One quick flash of standby light at switch on, very faint ticking from power supply, low 125v supply | R813 and 821, 330k 1/2 watt | ||
| Panasonic | Z5 | Dead no st/by light | IC801 STR51424 | ||
| Panasonic | Z5 | Dead but standby light on Power supply chirping loudly, No 125V. | R812 33ohm metal film special from SEME part No. ERQ12HJ330. | ||
| Panasonic | Z5 | DEAD , IC801 GETTING WARM | D806 AU02V0 | ||
| Panasonic | Z5 | dead | REPLACE D806 PART. NO. AV02AVO | ||
| Panasonic | Z5 | Dead | D806 AU02V0 DIODE | ||
| Panasonic | Z421V TX21GV1 | Int switches off & on | IC1807 TOP210 chopper chip | ||
| Panasonic | Z421V TX21GV1 | Flyback lines at top - Txt OK | Remove by going thro' self test proc - press vol down on set & status button on hset | ||
| Panasonic | Z4 TX21M1T/BK | Blanking from LHS with ragged edges | 10µ 250v on main pcb rear edge | ||
| Panasonic | Z4 TC15M1RP | Dead with STR54041 & 2SD965R Trs s/c | also 4R7 surge res o/c - also replaced 10µ 63v & 100µ 6v3 elects on psu pri & check for dry joints | ||
| Panasonic | Z4 Chassis | When chan stored in a prev stored location, all chans appear the same | Check for dry joints around link J10 on Txt pcb | ||
| Panasonic | Z4 Chassis | The Panasonic Z4 Chassis | See TV Mag Sept - Nov 1994 | ||
| Panasonic | Z4 Chassis | Slight tuning drift, no sound, no Vol OSD (other OSD OK) | Insufficient sync drive to Q1272 base. C524 180pF connected to pin 14 IC521 leaky |