Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
SHARP | 4BS-A | Quando a fonte não regula. | Mudar: C 714 .47 uF C 717 4,7 uF C 718 1 uF dica enviada por: José Luis Calçada | ||
SHARP | C1430 | Tv parada. Tem os 300v no coletor de Q701, mas na base e emissor tem só 0,4v em vez de 114v | C706 em curto | ||
Sharp | CV2123 CS | Field fault / general modification | Add a 1N4148 diode from the emitter of Q509 to cathode of D513 cathode to emitter of Q509, Pt No. RH-DX0045BMZZ, change R534 to 390ohms Pt No. VRS-TV1JD391J and add a fuse in series with L607 and L608 Pt No. QFS-J1023CEZZ | ||
Sharp | 66FW53 widescreen DA-100 , 50 and 100Hz series | E/W fault | Coil L603 part num RCILP0286BMZZ had severely burnt up and Q506 E/W driver 2SD2391 Part num RH-TX0151BMZZ was short circuit. If you have this fault check L604 for invisible dry joints, if you don't you may find you still have an E/W fault when you have replaced the faulty parts | ||
Sharp | DV3760H | Dead, led flashing red/green at first, then going to red standby | Replace C604 1000uF, 16v elec. cap. It is in the decoupling circuit for the 5 volt supply | ||
Sharp | TV14 Cinema Borg | When set switched on "ENTER YOU LOCKCODE" appears on screen, customer had forgotten the lock code | Replaced the Microprocessor64 pins | ||
Sharp | 66FW53H | Dead - Neon lit | R713 and R714 560K high or o/c | ||
Sharp | 66FW53H | Dead - neon lit ... another fault! | Check the BZW04145 diode across C720, if short circuit, replace and also replace opto-isolator IC704 MOC8106 and IC706 TL431 voltage reference. You can put an 817 opto-coupler in diagonally | ||
Sharp | 66FW53H | Colours ramping, poor greyscale | Replace IC1002/3, Set will need reprogramming afterwards | ||
Sharp | 51DT25H U | No audio R305 o/c | R305 2.2ohm, Q3021 BC636, Q3011 BC635 | ||
Sharp | 4BSC | Low width with lines across screen and feathered edges | Replace C623 and C602 | ||
Sharp | 66FW53H DA100 | Failure of Q601 BUH515 and possibly Q506 | Found dry joints on C613. Also R613 had burnt top of C613. Fitted new parts, found Circuit no longer available. Sharp by name sharp by nature came to mind. Set only just over two years old | ||
Sharp | 54DT25S | Frame foldover | Check C713, Q510 and Q505 | ||
Sharp | 54DT25S | Dead with ticking noise from line | Replaced C622, C604 and Q509 | ||
Sharp | 66FW53H FW | Dead only neon lit | Check D735 across 150v rail, if s/c you will need to replace the opto and the D735. Check Q601 line o/p transistor as this may also be leaky |