Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sharp | DV5161H | WORKS FOR 1min THEN SHUTS OFF. ALL SECONDARY SUPPL | C711 1n 2kv | ||
Sharp | DV5161H | White raster with fb lines & trips | R612 22R fusible o/c | ||
Sharp | DV5161H | St/by only | No 12v supply; D602 1N4936 o/c | ||
Sharp | DV5161H | No sound/pic - screen lit with lines with half screen darker | FOP chip - gets hot! | ||
Sharp | DV5161H | HEIGHT VARIES WITH PIC CONTENT FIT MODS , ADD 270K | ADD 110K 1/8W BETWEEN CATHODE OF D801 AND GROUND , - CHANGE C832 TO 100nf , CHANGE NVM TO NEW SOFTWARE VERSION ( Sharp CH-IX1 | ||
Sharp | DV5161H | Electronic Screwdriver | Wire link pins 3 & 6 of plug TB on txt panel. Press "mode" on hset. "Serv" appears on screen. Remove link & use up/down buttons to view menu settings. Press "Mode" button again to exit settings | ||
Sharp | DV5161H | Dead green LED lights briefly flashing red | Dry joints C610 near LOPTx | ||
Sharp | DV5161H | Dead - loptr s/c - R604 flaming | R649 15R 1W across Q1010 coll/emitter hi res & replace R604 3k3 1/3w safety res | ||
Sharp | DV5161H | Blows lop tr aft few mins | Tuning caps C607, 608, 609 & 610 | ||
Sharp | DV5151H | LOSES COL AFTER CHAN CHANGE , SLOW TO LOCK | ADD 8.2 MEG BETWEEN PINS 25 AND 39 OF IC801 Sharp VRD-RA2BE825J | ||
Sharp | DV5150H | Reverts to st/by aft 2 secs | No 24v supply to FOP chip as R612 3R3 safety res o/c - Sharp mod - fit 2R2 safety res & link J13 replaced by 1R2 ½w res | ||
Sharp | DV5150H | Int goes off with crackle | Dry joints C603 6n8 1.5kv | ||
Sharp | DV5150G | Dead led flashes red | Check R612, 621 & C714 1000µ? 16v | ||
Sharp | DV5150G | Dead | R728 3k3 safety res overheating, chopper tfmr shorted turns (draws 500mA off load -should be only 120mA) | ||
Sharp | DV5150 S3B | Field top stretched | C712 100µ 35v in 24v supply |