Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por:![]() |
---|---|---|---|---|---|
Sony | D3 | BATTERY WILL NOT TAKE CHARGE | Battery will not charge and hold charge. | ||
Sony | SL300 | WILL NOT LOAD | Will not load tape. | ||
Sony | SLHF900 | NO DISPLAY | Unit had no display. | ||
Sony | CDP110 | MAKES NOISE AND DOOR WILL NOT STAY CLOSED | Unit makes noise and door will not stay closed. | ||
Sony | CCDV1 | FLASHES | Video flashes. | ||
Sony | KV2775R | PICTURE SHIFTED, REPLACE IF BLOCK 1-464-597-11 | When TV was first turned on, picture was good. After fiveminutes, the picture had shifted. | ||
Sony | KV25XBR | VIDEO BLANKED OUT | By doing a voltage analysis on the D board, I was able totrace to Q1504 - E2.4, B.4, C.12.9, Q1506, E2.4, C.2.4, B.2.4 checkedtransistors they were ok. Checked surrounding components R1537 Changedvalue. | ||
Sony | SL250 | CHANNELS (STATIONS) CANNOT BE TUNED IN | Channel display can be seen, however, stations cannot be tunedin. | ||
Sony | CDP110 | IC3 FAILURE | Four units with distorted audio of varying degrees - somequite severe. Found IC303 (CXD1135Q) defective. This was after theRAM chip was changed on two of the units. | ||
Sony | KV27HFR | NO VERTICAL SYNC ON COPY-GUARDED TAPE, ADD CAPACITOR | When playing certain copy-guarded tapes, namely, two WaltDisney tapes, this TV model has absolutely no vert. sync. Picture rollsupward rapidly. This problem was noted on two other sets, same model i.e.KV27HFR. Same symptom was present using two differ | ||
Sony | VTX1100R | PROFEEL TUNER | Intermittent shutdown when unit gets hot. | ||
Sony | WMF69 | MOTOR MOUNT HOLES POSITIONED WRONG ON NEW MOTORS | The servo board solders onto motor in one way. The holes tomount motor to deck assembly are drilled in wrong position. When motorservo board is properly attached, the motor will not fit onto deckproperly or the servo board is not positioned properly. | ||
Sony | CCDV100 | ELECTRONIC VIEWFINDER COMPATIBILITY | Can an NTSC viewfinder be used on the PAL camera? -HQ COMMENTS: No, pix will roll continuously. | ||
Sony | SPP80 | SPP80 BATTERY PART NUMBER | We have a customer that needs a battery for an SPP80 telephoneWe have no service information on this phone. I have made a half dozenphone calls on this subject. I am no further ahead at this time. If youcould help in this area, I would appreciate it. | ||
Sony | TCW21 | NO P/B OR REC WITH B DECK | No P/B or REC with B deck. No indication on level meters.A deck PLAYBACK OK. Found IC309 Pins 9, 13 held at -5.8V instead of+6.4V. Traced switching logic back to Pin 2 of IC402. It measured0.6V instead of -5.8V. Found IC401 at Pin 6 was drawing exce |