Dicas Reparação SONY




Modelo - Chassis


Pesquisa: SONY Enviar Dica Resolvida
Resultados 18940
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCFSW360
EATS TAPES Eats tapes.
SonyKV2792R
NO SOUND, RESOLDER T-801 No sound. Pix OK.
SonyCCDV110
CAMERA WOULD FLASH BRIGHT/DARK Video from camera had what appeared to be incorrect horiz.freq. and would flash bright/dark. Playback from VCR section OK.Found X701 on the CP-18 board had no CW output. The output pulsed, butwould not ring.
SonyCDP510
SKIPPING ON FIRST TRACK Stock unit. Skipping on first track. Found sled drive vol-tage going to 1.8V-2.0V before the sled would move. Loosened sled motorholding screw and repositioned worm gear to open meshing with sled gear.Now drive voltage goes to 0.6V and sled moves smoo
SonyCCDV110
MULTIPLE IMAGE IN VIEWFINDER AND POOR SOUND Multiple image in viewfinder and poor sound.
SonyCCDV110
UNIT WOULD NOT POWER-UP Would not power up.
SonyCDP510
DISC WILL NOT CLAMP AFTER LOADING Breakage of chuck arm and loss of chuck arm roller.
SonyTCR302
NO RECORDING FROM ONE CHANNEL No record one channel. Found record level control RV301 open.
SonyTCW530
RECORD LEVEL WILL NOT SET FROM TAPE Record level will not set from tape, everything else OK.
SonyXR27R
RIGHT SIDE DEAD Right side dead.
SonyCDP55
UNIT SKIPS Transformer buzzing and unit skips.
SonyCPD1302
DEAD The +15V, +24V and +80V are loaded down from the D3 connectoron the D board. Only voltage present is the VCC voltage. The 24 voltprotector D5001 is leaky.
SonySLHF900
AM INTERFERENCE (1340 KHZ) A customer lives about 1/2 mile from AM radio station broad-casting at 1340 kHz. The unit is displaying diagonal color lines whenplaying back an off-air recorded signal. -HQ COMMENTS: I am sending you an AC noise filter and a video headshield cover. P
SonySL5000
TANTALUM CAPACITOR FAILURE Upon installation of tantalum capacitor kit as per S/B #276C54 becomes leaky after about one week. This is the third such unit inabout one month that has done this.
SonyXR33
UNABLE TO PRESET MEMORY #1, #2, #3 & #5 presets inop. #4 works normally. #6 willpreset a station, but displays its position as #2. I noticed I had topress hard on the keys to get a response.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads