Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV8AD20 | TUNING INDICATOR | Tuning indicator bar is 1/8 inch shifted from thecorresponding channel numbers. Can this be corrected? -HP COMMENTS: This bar can not be adjusted. Its length versus channelnumbers is determined by IC program (ICOO1). | ||
| Sony | SLV757MC | TAPE STABILIZER LOOSE IN UNIT | Tape stabilizer guide rolling around loose in transport -customer pulled out through cassette door. Second unit with sameproblem. | ||
| Sony | GEN-TVP | SAP BROADCASTERS IN NY HAVE CHANGED AUDIO INFORMATION | I received inquiry concerning why there were no longer radiobroad casts on SAP mode on channel 41, 11, 9. According to the individualstations Engineering departments, music program has been replaced with amono duplicate of TV stations programming. | ||
| Sony | KV27XBR10 | SCHEMATIC ERROR, DIODE D-106 NOT USED, REFER TO TVP FLASH 37 | Page 38 of service manual shows D106 between pin 1 of IC101and L101. | ||
| Sony | WMA12 | ORIGINAL MOTOR IS STILL SUPPLIED | The motor in this unit is a approximately 1 inch across withmounting screw holes approximately 7/8 inches apart. The replacing motoris approximately 7/8 inches across with mounting screw holes approximately3/4 inches apart. -HQ COMMENTS: Apparently the | ||
| Sony | CDXR77 | MISSING PART NUMBER - FEED GUIDE FOR OPTICS | The part number for the feed guide shown on page 45 of theCDX-R79 manual above the optical block reference 926 is missing. Do youhave a part number? -HQ COMMENTS: The part number is 2-640-654-03. Please add this numberto your service manual. | ||
| Sony | CDXR79 | MISSING PART NUMBER - FEED GUIDE FOR OPTICS | The part number for the feed guide shown on page 45 of theCDX-R79 manual above the optical block reference 926 is missing. Do youhave a part number? -HQ COMMENTS: The part number is 2-640-654-03. Please add this numberto your service manual. | ||
| Sony | GENERAL | PART NUMBERS OF DOUBLE SIDED TAPE | When either the 6mm wide (7-632-453-52) or 9mm wide(7-632-453-53) double sided tape is entered in the computer for ordering,both are subbed to 9-910-999-88. This is a number that has (unnecessaryfor normal repair) for a description. Please advise how w | ||
| Sony | CCDV5 | LENS/AUTO FOCUS HUNTING | Intermittent or constant hunting of auto focus. | ||
| Sony | SPP300 | CUSTOMER OPERATION MANUAL | On page 7 of instruction manual they show the AC-T40connected to the base unit. I believe the AC-T90 is the adaptor usedfor the base station. | ||
| Sony | KV8AD10 | TUNING INDICATOR | Tuning indicator bar is 1/8 inch shifted from thecorresponding channel numbers. Can this be corrected? -HP COMMENTS: This bar can not be adjusted. Its lengh versus channelnumbers is determined by IC program (ICOO1). | ||
| Sony | CDXR66 | WILL NOT ACCEPT SPECIFIC DISC | We have had reports that the above unit will not accept thefollowing disc: Eric Clapton - Journeyman by Reprise Records. The disc istransparent at the edges and therefore will not activate the sensors. -HQ COMMENTS: Unfortunately, some discs are manufa | ||
| Sony | CFM31 | PART NUMBER MISSING FOR LOCK PLATE BUTTON | Lock plate button on page 22 of the service manual does nothave a part number listed. -HQ COMMENTS: The part number of the lock plate button is 3-561-833-00. | ||
| Sony | KV32HSR10 | LINES IN PICTURE, REPLACE IC-501 AND RESOLDER C-504 | Unit had lines in the top and bottom of the picture whichappeared to be caused by a defective vertical output. We found that inaddition to the vertical output C-504 was cold soldered which probablygave rise to the initial problem. Resoldering C-504 and | ||
| Sony | CCDTR5 | CASSETTE COMPARTMENT WILL NOT RELEASE | Post that holds cassette compartment latch is loose. locatednear No. 165 on LS chassis. The post is mounted on the LS chassisassembly. -HQ COMMENTS: Replace the LS chassis assembly: part number X-3727-953-2. |