Dicas Reparação SONY
Modelo - Chassis
Pesquisa: SONY Enviar Dica Resolvida
Resultados 18945
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF50 | PARTIALLY EJECTS AND DAMAGES TAPE | Intermittent shutdown - would eject part way then reloadeating tape. | ||
| Sony | CCDF70 | NO ZOOM MOTOR DRIVE | No zoom motor drive. | ||
| Sony | STRAV700 | AFTER A FEW MINUTES THE +/- 15V LINES DROP TO 0V | The +/- 15V lines drop to 0V after a few minutes. | ||
| Sony | D4 | INTERMITTENT NO POWER | Unit does not turn on - but turns on when upper lid is pusheddown. The open leaf switch (S-801) does not contact well because the openleaf switch is bent or the pushing lever in the upper lid is worn out. | ||
| Sony | D15 | NO SPIN/SCRAPING NOISE DURING PLAY | The height of the turntable is too low. It should be 1.5mm or2mm from MD chassis. A disc does not spin because there is no gap betweenthe turntable and MD chassis or the gap between them is just too small. Adisc touches the MD chassis intermittently. | ||
| Sony | MDP200 | RADIO FREQUENCY INTERFERENCE | Unit had herringbone type interference caused by A.M. radiostation 850 K.C. WHDH Needham, Massachusetts (approximately 1 1/2 milesaway). Problem showed up in both video and R.F. out. The interference isA.C. line related. | ||
| Sony | GEN-CAM | 8MM LAPPING TAPE | What is the part number for the 8mm lapping tape? -HQ COMMENTS: The part number for the 8mm lapping tape is 8-883-103-10. | ||
| Sony | WMF100II | TAPE WILL NOT PLAY OR EXCESSIVE WOW AND FLUTTER | Pinch roller touches part of cassette shell causing excessivewow and flutter or no play. | ||
| Sony | STRAV900 | PART NUMBER NEEDED - INSULATING MICA | Is there a part number for the insulating mica for the outputtransistors (2SC3856 and 2SA1492)? -HQ COMMENTS: The mica insulators are shown on page 29 of the servicemanual as reference number 57. Part number is also listed it is4-885-901-31. | ||
| Sony | EVS700U | LP MODE PLAYBACK PICTURE IS DISTORTED WITH SELF-RECORDING | SP mode is ok. When I recorded and played it back in LP mode,one channel of RI waveform level is too small. | ||
| Sony | CCDF40 | WRONG PART NUMBER FOR DT-71 BOARD IN MANUAL | When servicer orders part number A-7061-127-A as in the manualfor the (DT-71) board, he receives an (AW-10P board). -HQ COMMENTS: Please change the service manual to the correct partnumber which is A-7068-127-A. | ||
| Sony | SLV555UC | TRANSISTOR TYPE CORRECTION | Transistor Q-102 is drawn as a PNP transistor on page 83 ofthe service manual. | ||
| Sony | CCDV3 | CCD-V3 LENS HOOD | Is there a repair kit for the CCD-V3 lens hood? -HQ COMMENTS: No there is no repair kit for this. | ||
| Sony | CCDV110 | HARD CASE MODEL NUMBER | Is the LCV-812 the correct hard case for the CCD-V110? -HQ COMMENTS: Yes, the LCH-V200 may also be used. | ||
| Sony | SLHF900 | ASSEMBLE EDITING IS NOT ACCURATE | When assemble editing is used, the SL-HF900 could be off by asmuch as five frames. -HQ COMMENTS: This is normal. The editing is not frame accurate. |