Dicas Reparação TOSHIBA
Modelo - Chassis
Pesquisa: TOSHIBA Enviar Dica Resolvida
Resultados 4731
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Toshiba | 1400RB | Auto tune not locking on | Replace QA06 no AFT on pin 8 ICA01 or Replace QA16 no sync on pin 9 ICA01 PtNo 233114689 | ||
| Toshiba | 1400RB | 500mA fuse F803 in HT line blew int | 3 rubber wedges on crt conductive - scan coils arcing to them | ||
| Toshiba | all new sets | unable to get install menu | software glitch. Put into stby and then switch on using R/C (not on/off switch). Set will now perform normally | ||
| Toshiba | 2,14E+06 | Set dead StBy LED goes out when R/C pushed but set | C815 ( 0.039uF ) | ||
| Toshiba | 2,12E+06 | LOW , DIST SOUND | D632 | ||
| Toshiba | 2939 | INT BLUE SCREEN | CHANGE TUNER | ||
| Toshiba | 2939 | FAINT BLUE SCREEN WITH NO MANUAL OR REMOTE FUNCTIONS | REPLACE ZP81 AND IC670 | ||
| Toshiba | 2812 | Servive Mode Access | press "F" and the av i/p key ( under the No 7) TOGETHER... then key 1 0 4 8 .. then "F" and green fastext key to move up the menu, "F" and Yellow to move down.. adjust with VOL up/down key | ||
| Toshiba | 2812 | Lack of width/tearing | C424 4.7uf 100v on the upright DPC board and C301 | ||
| Toshiba | 2812 | INT TRIPPING | GROUND PIN 52 OF IC501 | ||
| Toshiba | 2545 | NO TEXT OR REMOTE FUNCTIONS | REPLACE 27MHZ CRYSTAL | ||
| Toshiba | 2535 | DEAD , POWER SUPP IN OVERVOLTS MODE , 11v HT INSTEAD | CHECK IC670 , D670 - 675. TA8218AH ( VOLTS AT PIN 9 OF IC801 VARY , 5-8v. OP VOLTAGE CONTROL LOOP INOPERATIVE AS IC826 HAS NO S | ||
| Toshiba | 2512 | No st/by function | Q845 2SC2023, Q843 & CK842 | ||
| TOSHIBA | 2226 | SET SPRINGS TO LIFE AFTER BEING STUCK ON STANDBY | REPLACE C932 100MFD25V | ||
| Toshiba | 2226 | No line sync. | R402 ( 15k ) o/c. |