Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 3456
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Philips | G90B | No vertical deflection | +200 V(163) not present Replace R 3570 (8,2 Ohm; 4822 052 10828) | ||
| Philips | G90AE | Ragged verticals on some pictures. | C2630 ( 47uF ) HT reservoir con. | ||
| Philips | G90AE | No vertical deflection | No vertical control signal on pin 1 IC 7470 Replace IC 7470 (TDA 2579/N6; 4822 209 72363) Replace D 6465 (BAS 32L; 4822 130 80446) | ||
| Philips | G90 | verticals corrugated | C2630 ( 47uF ) | ||
| Philips | G110 | vertical shift incorrect, after replacing a 28" BL-CRT. | Mount in parallel of R3512 a resistor of 2K2 (4822 116 52256) or 2K7 (4822 116 52263). | ||
| Philips | G110 | vertical bars on channel 2 and 4. | For sets equiped with a .4 picture tube panel, on channel 2 and 4 there are vertical bars (spook) visible at the left side of the picture. To solve this problem remove on the picture tube panel capacitors 2417, 2418, 2419 and replace jumper 9302 by a cap | ||
| Philips | G11 | Black vertical bar in centre of picture. | Check for solder bridge under chip capacitor C2460 | ||
| Philips | FL4.27 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL4.26 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL4.17 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL4.16 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL2.26 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL2.24 | Sometimes vibration in vertical direction. | Replace C2410 (150nF 5%; 4822 121 41854) on LSP. | ||
| Philips | FL2.24 | Distorted East-West & jitter on vertical side lines at switch-on. | In the FL1.16 and FL2.16: Replace position T7610 on the LSP by BD536FI (4822 130 63508). Delete position 2615. Replace position 2611 on the LSP by 2,2 uF (4822 124 41576). Replace position 3608 on the LSP by 1k (4822 051 10102). In the FL2.24: Replace po | ||
| Philips | FL2.16 | vertical jumping picture. | 32Mhz unstable. Watchdog gives reset to IC7120. Check IC7120 (PCF83C652P; 4822 209 33289). |